The 22451-1 mechanical seal (OEM cross reference 648414308) is a precision-engineered, single-cartridge mechanical seal designed as a direct replacement for the Mission Magnum 3×2×13 centrifugal pump. Built for extreme abrasion and corrosion resistance, this 2.5‑inch (Type 1‑2.5") seal is the preferred choice for oilfield drilling, mud transfer, and high‑solid slurry applications where reliability under harsh conditions is critical.
| Parameter | Value |
|---|---|
| Model Number | 22451‑1 (648414308) |
| Applicable Pump | Mission Magnum 3×2×13 |
| Seal Type | Single‑acting, inside‑mounted, multi‑spring, unbalanced |
| Shaft Size | 2.5 inches (Type 1‑2.5") |
| Pressure Rating | ≤ 16 bar (232 psi) |
| Temperature Range | -20°C ~ +220°C (-4°F ~ +428°F) |
| Permissible Speed | ≤ 20 m/s (65.6 ft/s) |
| Axial Movement Tolerance | ±0.5 mm (±0.02 in) |
Rotary & Stationary Faces: Tungsten Carbide (TC) – exceptional wear resistance against abrasive drilling muds.
Secondary Seal (O‑Ring): Viton (FKM) – withstands high temperatures and aggressive chemicals.
Springs & Metal Parts: Stainless steel – corrosion resistant for long service life.
The 22451‑1 mechanical seal is engineered for neutral to strongly alkaline (pH 7–14) media, including:
Water‑based and oil‑based drilling fluids
Bentonite slurries
Cement slurries
High‑solids muds in oil & gas drilling
Industrial slurry transfer pumps
Note – Not recommended for acidic fluids (pH <7) without consulting the manufacturer.
Direct fit replacement for Mission Magnum 3×2×13 – no modification required.
Multi‑spring design provides even face loading and compensates for slight shaft runout.
Tungsten carbide vs. tungsten carbide friction pair ensures long wear life in abrasive service.
Viton O‑rings maintain elasticity across the full -20°C to +220°C range.
Unbalanced type is cost‑effective for moderate pressure applications (≤16 bar).
Verify pump shaft axial movement does not exceed ±0.5 mm.
Ensure the seal chamber is clean and free of large solids before installation.
Lubricate the O‑ring and shaft with compatible grease (e.g., silicone or mineral oil‑based) to avoid rollover.
For first startup, run the pump with clean fluid to flush debris, then introduce slurry gradually.
Genuine 22451‑1 mechanical seals and aftermarket equivalents are available from stock. For price, technical datasheet, or custom material upgrades (e.g., silicon carbide faces, FFKM O‑rings), contact:
Email: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.