Hydraulic Accumulator Working Principle and Sizing Guide

2026-10-23 22:41

Hydraulic Accumulator Working Principle and Sizing Guide

This guide explains the working principle of hydraulic accumulators, how they utilize the compressibility of gas for energy storage, and key considerations for pre-charge pressure and sizing.

Working Principle

A hydraulic accumulator is designed to accumulate pressured liquid. Fluids are practically incompressible and cannot store pressure energy. In accumulators, the compressibility of gas (usually nitrogen) is utilized for storing fluids. The accumulator draws in fluid when pressure increases and the gas is compressed. When pressure drops, the compressed gas expands and forces the stored fluid into the circuit.

Pre-charge Pressure Selection

The bladder accumulator allows a volume utilization rate of 75% of the actual gas capacity. Therefore, the ratio between pre-charge pressure (P0) and maximum working pressure (P2) should not exceed 1:4. Additionally, the pre-charge pressure must not exceed 90% of the minimum system pressure (P1). Following these rules ensures a long bladder service life.

  • Energy Storage: P0 ≤ 0.9 × P1
  • Absorbing Impact: P0 = (0.6 - 0.9) × P1
  • Absorbing Pulsation: P0 = 0.6 × P1 or 0.8 × P1

Capacity Calculation

The compression and expansion processes follow the gas state equation. Ideal gas is P1 × V1 = P2 × V2 = P3 × V3. The formula must account for the polytropic index 'n'. Slow processes are close to isothermal (n=1), while rapid processes are adiabatic (n=1.4 for nitrogen).

Frequently Asked Questions

What happens if the pre-charge pressure is too high?

A pre-charge pressure that is too high can reduce the volume of fluid the accumulator can store and may damage the bladder.

Can I use oxygen in the accumulator?

No. Only nitrogen gas is allowed. The use of oxygen or other combustible gases is strictly prohibited.

Contact

For further technical support, contact HYRIG: info@hyrig.com

Page last updated: 2023-10-27

Name:
Message:
Verification code:
Submit
Comment