HYRIG can supply the Z63Y series welded connection mud gate valve range and its replacement parts. The Z63Y-50-35 is a manual, rising-stem gate valve with a 2" (DN50) bore, engineered for abrasive drilling mud service at pressures up to 5,000 psi (35 MPa). It features weld-end connections and a precision-lapped metal-to-metal (hard) seal for permanent manifold integration.
Note: The Z63Y-50-35 model is produced in two dimensional variants to match different manifold weld-prep standards.
| Model Number | Nominal Diameter | Working Pressure | L (Length) | H (Height) | A (Width) |
|---|---|---|---|---|---|
| Z63Y-50-35 (Variant 1) | 50 mm (2") | 35 MPa (5,000 psi) | 230 mm | 443 mm | 70.5 mm |
| Z63Y-50-35 (Variant 2) | 50 mm (2") | 35 MPa (5,000 psi) | 225 mm | 416 mm | 61 mm |
| Z63Y-50-70 | 50 mm (2") | 70 MPa (10,000 psi) | 275 mm | 445 mm | 74 mm |
Data source: Technical data table.
Need a higher pressure rating? View the Z63Y-50-70 Welded Valve or explore the full Z63Y Welded Mud Valve Series.
Because this valve is welded directly into the manifold, the exact face-to-face length is critical for drop-in replacement:
These dimensions are critical for replacing existing welded valves. Verify your current pipe cut-out length (L-dimension) before ordering.
The Z63Y series utilizes a parallel metal-to-metal sealing design (indicated by the "Y"). The solid slab gate is sandwiched between two floating seat rings. When the valve is closed, line pressure pushes the downstream seat against the gate, creating a hard seal. Hard-facing on the seats provides drop-in reliability in abrasive mud.
Replacing an older welded mud valve? Here is what to verify:
The Z63Y-50-35 is specifically suited for:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure whether you need Variant 1 or Variant 2? Tell us the exact cut-out length of your current pipeline, and our engineers will match the correct Z63Y model.
We supply replacement parts for the Z63Y-50 series, including gate and seat assemblies, stem packing kits, and handwheels. See our Z63Y Welded Mud Valve Parts page for compatible repair kits.
Q: Why are there two different lengths for the Z63Y-50-35?
A: They are designed to match different historical manifold standards or pipe schedules. Variant 1 is 230 mm long, and Variant 2 is 225 mm long.
Q: What is the maximum pressure for this model?
A: The maximum working pressure is 35 MPa (5,000 psi).
Q: Does this valve use metal-to-metal sealing?
A: Yes. The "Y" in Z63Y indicates a hard metal-to-metal seal designed for abrasive mud.
Q: What is the typical lead time?
A: Standard lead time is 15-20 days. Contact us for expedited options to avoid drilling downtime.
For Z63Y-50-35 welded mud gate valve selection and replacement parts, contact HYRIG: info@hyrig.com
Page last updated: 2026-11-08
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.