Overview
The HYRIG 4" 5000psi Demco mud valve can be configured with various materials and seals to match the specific challenges of your well environment. Use this guide to select the optimal configuration for maximum reliability and lifespan in large‑bore, high‑flow drilling operations.
Service Condition Categories
| Condition | Media Characteristics | Recommended Configuration |
|---|---|---|
| Standard Drilling Mud | Water‑based mud, light slurry | 4130 body, Nitrided 410 SS gate, NBR seals |
| High‑Temperature / Chemical | Oil‑based mud, elevated temps (>100°C) | 4130 body, 410 SS or 316 SS gate, HNBR seals |
| Sour Service (H₂S / CO₂) | NACE MR‑01‑75 environment | NACE‑compliant 4130 body, 410 SS or Monel gate, HNBR seals |
| Abrasive / High‑Solids | High sand content, cement, fracturing fluids | 4130 forged body, Nickel‑plated/Aluminum Bronze/Monel gate, HNBR seals |
| Corrosive / Saltwater | Saltwater injection, corrosive fluids | 4130 body, 316 SS or Monel gate, HNBR seals |
Seal Material Selection Guide
| Seal Material | Temperature Range | H₂S Resistance | Abrasion Resistance | Best Application |
|---|---|---|---|---|
| NBR (Nitrile) | -40°C to +100°C | Limited | Good | Standard water‑based mud |
| HNBR | -30°C to +150°C | Excellent | Very Good | H₂S, high‑temp, oil‑based mud, abrasive service |
Gate Material Options
| Gate Material | Wear Resistance | Corrosion Resistance | Best Application |
|---|---|---|---|
| 410 SS, Nitrided | Excellent | Good | Standard drilling mud |
| Nickel‑Plated Carbon Steel | Very Good | Good | Abrasive slurries |
| Aluminum Bronze | Excellent | Excellent | Corrosive/abrasive service |
| Monel | Excellent | Excellent | Severe H₂S / corrosive |
| 316 SS | Good | Excellent | High‑corrosion service |
End Connection Selection Guide
| Connection | Best For | Advantages |
|---|---|---|
| Butt‑Weld (BW) | Permanent high‑pressure piping | Leak‑free, high integrity |
| Flanged (RTJ) | Standard wellhead equipment | Easy disassembly, standardized |
| Threaded (NPT) | Auxiliary lines, maintenance points | Quick installation |
| Hammer Union | Quick‑connect mud lines | Rapid connect/disconnect |
API 6A Material Classes
| Class | Service Conditions | Recommended Configuration |
|---|---|---|
| AA | General, non‑corrosive | 4130 body, 410 gate, NBR seals |
| BB/CC | Mild/Moderate corrosion | 4130 body, 410 gate, HNBR seals |
| DD | Sour (H₂S) | NACE 4130 body, Monel gate, HNBR |
| EE/FF | Severe Sour + Corrosion | NACE 4130 body, Monel/316 gate, HNBR |
Ordering Information
When placing an order, please specify:
Size (4")
Pressure class (5,000 PSI)
End connection type
Working conditions (temperature, media, H₂S content)
Material class required
For expert consultation on your specific downhole conditions, reach out to info@hyrig.com.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.