BOMCO F2200HL Ceramic Liner – Full Technical Introduction
The BOMCO F2200HL ceramic cylinder liner is a premium-grade fluid end component specifically engineered for BOMCO F2200HL high-pressure triplex mud pumps (rated 2200 HP, maximum working pressure 52 MPa / 7500 PSI). It is designed as a direct OEM replacement, fully interchangeable with original BOMCO parts, and complies with API 7K certification for global drilling safety and reliability.
Material & Construction
The liner adopts a proven composite structure: an outer shell made from forged 45# carbon steel (AISI 1045) with tensile strength ≥610 MPa and HB 180-220 hardness, combined with an inner sleeve of ZTA (Zirconia Toughened Alumina) ceramic. The ZTA material offers a hardness of 92-94 HRC – significantly harder than traditional bimetal or high-chrome liners – while maintaining fracture toughness through zirconia reinforcement. Hot-press interference assembly creates a permanent metallurgical bond between steel and ceramic, eliminating any relative movement under pump operation.
Performance Advantages
Wear Life: 4000+ operating hours in real drilling conditions, extending service life 5-10 times compared to conventional liners.
Working Pressure: Sustainably operates at 7500 PSI (517 bar) without deformation or fatigue failure.
Surface Finish: Mirror honed to Ra ≤0.4μm (4-8 RMS), minimizing piston seal wear and reducing friction loss.
Corrosion Resistance: Unaffected by high chloride, hydrogen sulfide, or acidic drilling fluids that rapidly degrade metal liners.
Specifications Summary
| Parameter | Value |
|---|---|
| Model | BOMCO F2200HL |
| Liner OD options | Standard OEM dimensions |
| Bore diameter | 160 – 230 mm |
| Stroke | 356 mm (14") |
| Ceramic hardness | 92-94 HRC |
| Steel shell hardness | HB 180-220 |
| Max pressure | 7500 PSI (52 MPa) |
| Standard | API 7K |
Applications
Onshore and offshore oil & gas drilling
Deep well and ultra-deep well high-pressure operations
High-sand content drilling fluid environments
Corrosive mud with high chloride, sulfide, or CO₂/H₂S
BOMCO F2200HL mud pump overhaul and maintenance programs
Installation & Care
Use soft padding during handling; avoid dropping or striking the ceramic sleeve. After installation, ensure perfect alignment between piston and liner to prevent eccentric wear. When the pump is idle below 0°C, completely drain mud to avoid freezing and ceramic cracking. Always use wooden blocks for adjustment – never strike the liner with hard metal tools.
Why Choose Our BOMCO F2200HL Ceramic Liner?
API 7K certified for global drilling standards compliance
ZTA ceramic offers superior toughness over pure alumina
Forged steel shell withstands extreme cyclic pressure and vibration
Full size range (160–230 mm) for all F2200HL configurations
Fast global shipping and professional technical support
Contact us today for a quote or to verify compatibility with your BOMCO F2200HL mud pump.
Email: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.