HYRIG can supply the 010 series hydraulic steering units. The 010 is a standard design Power Steering Unit (PSU) featuring optimized control valve design, low hydraulic noise, and special casting for low pressure drop. It is available as a compatible replacement for standard configurations.
With displacements ranging from 80 to 500 ml/r, the 010 series is available in three basic systems: Open Center, Closed Center, and Load Sensing. It can be directly connected to FK/FKS combination valve blocks to fulfill various system requirements.
Data source: Technical data table
| Displacement (ml/r) | Length L (mm) | Max System Pressure (MPa) | Max Back Pressure (MPa) | Input Torque (N·m) |
|---|---|---|---|---|
| 50 | 139.5 | 16 | 2.1 | 2.8 - 4.0 |
| 63 | 141.5 | 16 | 2.1 | 2.8 - 4.0 |
| 80 | 141.5 | 16 | 2.1 | 2.8 - 4.0 |
| 100 | 144 | 16 | 2.1 | 2.8 - 4.0 |
| 125 | 147 | 16 | 2.1 | 2.8 - 4.0 |
| 160 | 152 | 16 | 2.1 | 2.8 - 4.0 |
| 200 | 157 | 16 | 2.1 | 2.8 - 4.0 |
| 250 | 163 | 16 | 2.1 | 2.8 - 4.0 |
| 315 | 173 | 16 | 2.1 | 2.8 - 4.0 |
| 400 | 183 | 16 | 2.1 | 2.8 - 4.0 |
| 500 | 195 | 16 | 2.1 | 2.8 - 4.0 |
The 010 series features a standard flange mounting pattern. The interface can be equipped with short neck, long neck, or internal spline shafts.
| Dimension Item | Standard Value (mm) |
|---|---|
| Mounting Flange | 4-M10x1.5 (Depth 16) |
| Flange Bolt Pattern | 84 x 84 mm |
| Shaft Type | Short neck, Long neck, or Internal involute spline |
| Spline Data | 12 Teeth, 30° Pressure Angle, Pitch Dia. Φ19.05 mm |
Explore individual models for detailed ordering codes and port configurations:
Looking to replace an older standard steering unit? The 010 series is a reliable alternative. Here is what to verify:
Disclaimer: Eaton and Char-Lynn are registered trademarks of Eaton Corporation. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by Eaton Corporation.
Not sure which system type or port configuration fits your tractor? Tell us your pump flow and steering cylinder requirements, and our engineers will help you configure the exact model code.
Q: Is this an original Eaton Char-Lynn product?
No. HYRIG supplies independent, compatible replacement products. We are not affiliated with Eaton Corporation.
Q: What is the maximum system pressure of the 010 series?
The 010 series PSU is rated for a maximum system pressure of 16 MPa.
Q: Can I connect a valve block directly to this unit?
Yes, the 010 series is designed to be directly connected with FK or FKS combination valve blocks to provide system protection.
For 010 series hydraulic steering unit selection, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.