REXROTH Z2FS10AS2 Throttle Check Valve
Overview:
HYRIG can supply the REXROTH Z2FS10AS2 and related hydraulic components. The Z2FS10AS2 is a twin throttle check valve in a sandwich plate design, used for the main or pilot flow limitation of one or two actuator ports.
The Z2FS10AS2 is a meter-out (discharge throttling) valve on side A. It limits flow leaving the actuator, which is essential for controlling negative loads and preventing runaway. The integral check valve allows free flow in the reverse direction.
The Z2FS10AS2 is a meter-out (discharge throttling) valve on side A. When replacing, verify the original throttling position:
Installing a meter-in valve where a meter-out was specified will alter the circuit's load-holding behavior.
Used in REXROTH sandwich valve stacks. For related components, view REXROTH Flow Control Valves.
Not sure whether your original valve was meter-in or meter-out? Check the nameplate for the `S` vs. `S2` code, or contact HYRIG with a photo.
Suitable for controlling actuator speed in machine tools, presses, and injection molding machines, where precise meter-out control is required.
Disclaimer: REXROTH is a registered trademark of Bosch Rexroth AG. HYRIG is an independent supplier of hydraulic components and is not affiliated with Bosch Rexroth AG.
Specifications:
Contact Us:
For REXROTH Z2FS10AS2 selection and ordering, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.