| Feature | DSA Sensor | HDD Sensor |
|---|---|---|
| Application | A2FM/E 23 to 200 | A2FM/E 250 to 500 |
| Number of Teeth | 38 to 67 | 78 to 99 |
| Installation | 1 mounting screw | 2 mounting screws |
Data source: Technical data table.
The sensor is mounted in a designated port on the motor housing. As the internal gear rotates, the sensor generates a pulsed electrical signal. The frequency of the pulses is proportional to the motor speed, and the phase difference between two signals can indicate the rotation direction.
Specify the motor model and the code `U` (Prepared for sensor) or `V` (Equipped with sensor) in the motor model code. For example: `A2FM63/61W-VAB05U` (Prepared for sensor) or `A2FM63/61W-VAB05V` (With sensor).
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Need help selecting the correct sensor option for your motor? Contact our engineers with your motor model.
Q: What is the difference between DSA and HDD sensors?
A: The DSA is used for smaller motors (23 to 200), while the HDD is a heavy-duty version used for larger motors (250 to 500) and has two mounting screws.
Q: Can I retrofit a sensor to an existing motor?
A: Retrofit is only possible if the motor was originally ordered with the prepared port (code U). Otherwise, the motor housing must be replaced.
Q: Does the sensor require a separate amplifier?
A: Yes, the sensor signal needs to be processed by a suitable amplifier (e.g., VT series) or a control unit.
For speed sensor selection for A2F motors, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.