HYRIG can supply the BM1 series hydraulic motors range. The BM1 is a small volume, spool valve, economical type motor featuring a compact design of spool and gear set, making it ideal for light to medium load applications.
With displacements ranging from 50 ml/r to 400 ml/r, the BM1 series offers a reliable and cost-effective solution for various hydraulic drive systems. The credible shaft seal design allows it to be used in parallel or in series, and the shaft rotation and speed can be controlled easily and smoothly.
Data source: Technical data table
| Displacement (ml/r) | Flow Cont. (LPM) | Speed Cont. (RPM) | Pressure Cont. (MPa) | Torque Cont. (N·m) |
|---|---|---|---|---|
| 50 | 45 | 879 | 12.5 | 81 |
| 63 | 45 | 720 | 12.5 | 110 |
| 80 | 60 | 740 | 12.5 | 129 |
| 100 | 60 | 589 | 12.5 | 161 |
| 125 | 60 | 475 | 12.2 | 202 |
| 160 | 60 | 370 | 12.5 | 245 |
| 200 | 60 | 296 | 11 | 286 |
| 250 | 60 | 237 | 11 | 360 |
| 315 | 60 | 189 | 10 | 406 |
| 400 | 60 | 149 | 8.5 | 435 |
Note: Continuous data refers to the max value of operating motor continuously. A simultaneous max RPM and max pressure is not recommended.
The BM1W is a wheel motor variant of the BM1 series, featuring radial bearings that can bear a larger radial force. It shares the same main specifications and performance data as the standard BM1, making it ideal for direct wheel drive applications.
The BM1 series is available with various flange and shaft combinations to match your specific mounting requirements. Please refer to the ordering information for exact dimensions.
| Shaft Type | Description |
|---|---|
| Shaft A | Cylindrical shaft: Φ25x40, parallel key: 8x7x32, link thread: M8 |
| Shaft B | Cylindrical shaft: Φ25x43, parallel key: 8x7x32, link thread: M8 |
| Shaft C | Cylindrical shaft: Φ25x43, parallel key: 8x7x32, link thread: 1/4-20UNC |
When replacing an older BM1 or equivalent motor, verify the following:
The BM1 series is widely used in:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Need a specific displacement? Explore the individual models: BM1-100 Hydraulic Motor, BM1-200 Hydraulic Motor, or contact us for a custom configuration.
Q: What is the difference between BM1 and BM2?
The BM2 series uses a gerotor design, providing higher efficiency and higher pressure capability compared to the BM1 series.
Q: Can the BM1W be used without a wheel?
Yes, but the BM1W is specifically designed with radial bearings to handle the side loads imposed by a wheel, making it less suitable for direct shaft-to-shaft couplings compared to the standard BM1.
For BM1 series hydraulic motor selection, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.