Q: What is the maximum torque of the ZQ168-50?
A: 50,000 N.m in low gear.
Q: What is the difference between high gear and low gear?
A: High gear provides faster rotation for spinning; low gear provides higher torque for final make-up and break-out.
Q: Can the ZQ168-50 replace a ZQ162/50?
A: The ZQ168-50 extends the drill pipe range while keeping the same 50,000 N.m torque class. Confirm jaw configuration, backup tong compatibility, and hydraulic supply before substitution.
Q: Does the ZQ168-50 have API 7K certification?
A: The source catalog references SY/T5074. API 7K configurations may be available; confirm the specific certification requirement with HYRIG before order.
Q: How do I order replacement parts without a part number?
A: Send the tong model, a photo of the installed component, and key dimensions such as jaw width, roller OD, and seal cross-section. HYRIG will match the part by system and configuration.
Q: Are ZQ162/50 and ZQ168-50 parts fully interchangeable?
A: Do not assume full interchangeability. Selected components may fit, but confirm by installed position, dimensions, and configuration before order.
Safety note: Hydraulic power tongs operate at high pressure. Selection, installation, and maintenance must be performed by qualified personnel in accordance with applicable safety standards and the manufacturer operating instructions.
Not sure about torque, flow, or part fitment? Send HYRIG your power unit flow and pressure, pipe schedule, and a photo of the installed component. HYRIG will confirm the suitable configuration before quotation.
For ZQ168-50 hydraulic power tong selection and replacement parts, contact HYRIG: info@hyrig.com