ZQ168-50 Power Tong Selection Guide | Flow, Torque & Gear Choice

2026-11-21 17:47

Key Facts

  • High gear is for faster spin-up; low gear is for final make-up and break-out torque.
  • At 120 L/min, high gear speed is 60 rpm and low gear speed is 4.1 rpm.
  • Low-gear torque rises with hydraulic pressure and reaches 50,000 N.m at 16.6 MPa.
  • Confirm pipe range, jaw configuration, and backup tong compatibility before order.

Flow vs Speed

Flow L/minHigh gear rpmLow gear rpm
120604.1
110553.8
100503.4
90453.1
80402.7
70352.4
60302.1

Pressure vs Torque

Hydraulic pressure MPaHigh gear N.mLow gear N.m
154,03459,237
143,76555,288
133,49651,338
123,22747,389
112,95843,440
102,68939,491
92,42035,542
82,15231,593

Source: ZQ168-50 technical data. Use these values for preliminary selection and confirm final settings with HYRIG.

Cross-Reference & Replacement

When comparing the ZQ168-50 with ZQ162/50 or other ZQ tongs, check four items: pipe OD range, required make-up torque, hydraulic flow and pressure, and jaw or backup tong configuration. A higher model number does not automatically mean a drop-in replacement. Confirm the power unit flow, pressure setting, and pipe schedule before selection.

Selection Support

Send HYRIG your power unit flow and pressure, pipe OD range, required make-up torque, and backup tong configuration. HYRIG will confirm the suitable gear range and jaw arrangement before quotation.

Applications

Suitable for offshore and onshore drilling and workover operations where drill pipe, casing, and tubing threads are made up and broken out. Confirm the tong configuration against the actual pipe schedule and hydraulic supply.

Safety note: Hydraulic power tongs operate at high pressure. Selection, installation, and maintenance must be performed by qualified personnel in accordance with applicable safety standards and the manufacturer operating instructions.

Frequently Asked Questions

Q: Should I use high gear or low gear for make-up?

A: Use high gear for fast spinning and low gear for final make-up and break-out torque. Confirm the final torque setting against your procedure.

Q: What flow is needed for 60 rpm high gear?

A: The table shows 60 rpm high gear at 120 L/min. Lower flow reduces high-gear speed accordingly.

Contact

For ZQ168-50 power tong selection, contact HYRIG: info@hyrig.com

Name:
Message:
Verification code:
Submit
Comment