HYRIG can supply a compatible replacement for the NOV FMS375 flush mounted slips. The FMS375 is a hydraulic floor-mounted slip rated at 500 sTon (454 Tonne) for 4½ to 14 in. casing.
NOV is a registered trademark of National Oilwell Varco. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by National Oilwell Varco.
| Parameter | Compatible FMS375 Replacement |
|---|---|
| Load Rating | 500 sTon (454 Tonne) |
| Pipe Size Range | 4½–14 in. |
| Rotary Size | 37½ in. |
| Max Back-up Torque | 54,232 ft-lbs (2,500 psi) |
| Weight (w/o slips) | 5,392 lbs (2,446 kg) |
| Weight (w/ slips) | 6,992 lbs (3,171 kg) |
| Replacement Compatibility | Replaces NOV FMS375 configurations |
Data source: Technical data and parts list.
| Parameter | Value |
|---|---|
| Minimum Inlet Pressure | 1,500 psi |
| Max Operating Pressure | 2,500 psi |
| Recommended Slips Up Pressure | 500–750 psi |
| Max Pressure Slips Down | 2,500 psi |
| Flow Rate | 5–12 gpm |
Explore the full series: NOV FMS Slips Compatible Replacement.
Data source: Technical data and parts list.
| Dimension | FMS375 Value |
|---|---|
| Rotary Size | 37½ in. |
| Pipe Size Range | 4½–14 in. |
The FMS375 uses hydraulic power to set and raise slips remotely. It is mounted flush with the rig floor to lower the casing connection height. Power-down force allows the FMS375 to take torque reaction from the tong.
Looking to replace a NOV FMS375? Check these points before ordering:
Used with rotary support tables and FMS control panels.
Used for casing running operations up to 500 sTon, providing backup torque and eliminating manual tong use.
Disclaimer: HYRIG supplies lifting equipment for industrial applications. Please verify local safety regulations and request valid certification documents before use. Never exceed the rated load capacity.
Not sure if this compatible replacement will fit your NOV FMS375 setup? Tell us your casing OD. Our engineers will verify the requirements before you order.
Q: Is this an original NOV product?
A: No. HYRIG supplies independent, compatible replacement products and is not affiliated with NOV.
Q: What is the maximum back-up torque of the FMS375?
A: The FMS375 compatible replacement provides up to 54,232 ft-lbs of back-up torque.
Q: Can the FMS375 be controlled remotely?
A: Yes, it is operated remotely via the FMS control panel from the driller's console.
Q: What is the typical lead time?
A: Lead time depends on configuration. Contact HYRIG for a confirmed delivery estimate.
For NOV FMS375 compatible replacements, contact HYRIG: info@hyrig.com
NOV is a registered trademark of National Oilwell Varco. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by National Oilwell Varco.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.