HYRIG can supply a compatible replacement for the NOV SSW40 pneumatic spinning wrench. The NOV SSW40 is a pneumatic spinning wrench that spins drill pipe and drill collars from 3½ to 9½ in. (89 to 241 mm).
NOV is a registered trademark of National Oilwell Varco. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by National Oilwell Varco.
| Parameter | Compatible SSW40 Replacement |
|---|---|
| Size Range | 3½–9½ in. (89–241 mm) |
| Air Pressure Min/Max | 90–125 psi (620–860 kPa) |
| Max Air Consumption | 250 cfm (530 dm³/s) |
| Max Stall Torque (5" pipe) | 1,100 ft-lbs (1,490 Nm) |
| Weight | 780 lbs (353 kg) |
| Replacement Compatibility | Replaces NOV SSW40 configurations |
Data source: Technical data and parts list.
| Parameter | Value |
|---|---|
| Pneumatic Power Requirement | 10.5 gpm (40 lpm) |
| Adjustment Mechanism | Easy adjustment screw (no roller change needed) |
Explore the hydraulic alternative: NOV Spinning Wrenches Compatible Replacements.
Data source: Technical data and parts list.
| Dimension | SSW40 Value |
|---|---|
| Size Range (inches) | 3.1/2 - 9.1/2 |
| Size Range (mm) | 89 - 241 |
The SSW40's four drive rollers, powered by two motors, are precisely controlled by the operator. This permits the slow walking in of drill collars or fast spinning in or out when tripping pipe. An easy adjustment screw eliminates the need to change rollers.
Looking to replace a NOV SSW40? Check these points before ordering:
Used with standard rotary drilling rigs and pipe handling systems.
Used to spin drill pipe and drill collars to bump up shoulders tight enough for final torquing.
Disclaimer: HYRIG supplies lifting and pipe handling equipment for industrial applications. Please verify local safety regulations before use.
Not sure if this compatible replacement will fit your NOV SSW40 setup? Tell us your pipe OD and air supply. Our engineers will verify the requirements before you order.
Q: Is this an original NOV product?
A: No. HYRIG supplies independent, compatible replacement products and is not affiliated with NOV.
Q: What is the maximum torque of the SSW40 replacement?
A: The SSW40 compatible replacement delivers a maximum stall torque of 1,100 ft-lbs on 5" pipe.
Q: Do I need to change rollers for different pipe sizes?
A: No, the SSW40 uses an easy adjustment screw to accommodate different pipe sizes without changing rollers.
Q: What is the typical lead time?
A: Lead time depends on configuration. Contact HYRIG for a confirmed delivery estimate.
For NOV SSW40 compatible replacements, contact HYRIG: info@hyrig.com
NOV is a registered trademark of National Oilwell Varco. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by National Oilwell Varco.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.