| OD mm | Depth of Cut A mm | Pitch mm | Depth of Cut B mm |
|---|---|---|---|
| 98.4 – 111.1 | 4.0 ± 0.7 | 991 | 4.1 |
| 114.3 – 130.2 | 4.8 ± 0.7 | 991 | 4.1 |
| 133.4 – 146.1 | 5.6 ± 0.7 | 965 | 6.5 |
| 149.2 – 161.9 | 6.4 ± 0.7 | 1067 | 6.5 |
| 165.1 – 177.8 | 7.1 ± 1.5 | 910 | 6.7 |
| 181.0 – 200.0 | 7.9 ± 1.5 | 911 | 6.8 |
| 203.2 – 225.4 | 8.7 ± 1.5 | 916 | 6.9 |
| 228.6 – 250.8 | 9.5 ± 1.5 | 917 | 7.0 |
| 254.0 – 276.2 | 10.3 ± 2.3 | 918 | 7.1 |
| 279.4 | 11.9 ± 2.3 | 920 | 7.3 |
Data source: Technical data table.
The spiral drill collar has three right-hand spiral grooves evenly distributed around the body. The groove depth and pitch are selected based on the outer diameter to optimize wall contact reduction while maintaining structural integrity. Verify the groove dimensions and OD clearance before ordering.
Spiral drill collars feature helical grooves machined into the thick-wall body. This design reduces the contact area between the collar and the borehole wall by approximately 40% compared to a standard smooth collar. The reduced contact area lowers the risk of differential sticking, particularly in deviated or horizontal wells where the BHA lies against the low side of the hole.
Replacing a smooth drill collar with a spiral design? Check these points:
If magnetic isolation is required above the bit, explore the Non-Magnetic Drill Collar page. For standard smooth collars, see the Drill Collar page.
Not sure which groove design or pitch suits your well? Send the hole size, well trajectory, and mud weight, and our engineers will recommend the appropriate spiral drill collar configuration.
Q: What is the primary purpose of the spiral grooves?
A: The grooves reduce wall contact area by about 40%, lowering the risk of differential sticking in directional wells.
Q: How many grooves are on a standard spiral drill collar?
A: The standard design features 3 right-hand spiral grooves evenly distributed around the body.
Q: Can spiral drill collars be made from non-magnetic material?
A: Yes, non-magnetic spiral drill collars are available upon request for applications requiring both magnetic isolation and reduced wall contact.
Q: Are the connections the same as standard drill collars?
A: Yes, standard NC and REG connections are used, with cold rolled or double-shoulder options available.
Q: How do I verify the right groove depth for my application?
A: Groove depth is matched to the OD and well conditions. Provide your drilling parameters for a recommendation.
Please follow standard industrial safety procedures during installation and maintenance.
For spiral drill collar selection and spare parts, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.