The Upper IBOP 110103-500 is manufactured to NOV Varco specifications for the VARCO TDS-8SA top drive system. It installs directly between the top drive spindle and the drill string, serving as the primary barrier against uncontrolled flow from inside the drill pipe.
The TDS-8SA is a medium-duty top drive commonly used on deep wells and hard formation drilling. The 110103-500 Upper IBOP is matched to its power and operational demands.
Direct fit for VARCO TDS-8SA top drive
Working pressure: 5,000 psi (34.5 MPa)
Full bore: 3-1/4" (82.6 mm)
Material: 4130 alloy steel forging
Seals: NBR (nitrile rubber) for standard service
Connections: 4-1/2" IF female (top) / 3-1/2" IF male (bottom)
Operation: Manual T-handle (clockwise close)
API compliance: API Spec 7-1, API 16D
Pressure-energized seats – tighter seal as differential pressure increases
Polished chrome ball – corrosion resistant, low friction
Forged steel body – no cast porosity, high structural integrity
Field-proven – used on thousands of TDS-8SA installations
Deep wells (3,500 – 5,000 m)
Hard formation drilling
Land rigs and offshore platforms
Non-sour environments (standard NBR version)
For pricing, availability, and technical datasheets:
Email: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.