| Attribute | Value |
|---|---|
| Product Type | Air-actuated, 2-plate pneumatic clutch |
| Compatible Series | WPT Power Grip 18/21 series |
| Plate Configuration | 2 plates |
| Static Torque | 157,000 lb-in / 17,740 Nm @ 100 psi |
| Typical Host | Drawworks, workover rigs |
| Replacement Compatibility | Form-fit-function replacement; verify shaft bore and adapter bolt pattern |
> Data source: Technical data table.
| Parameter | Value |
|---|---|
| Size / Diameter | 18 in |
| Plate Count | 2 |
| Static Torque @ 100 psi | 157,000 lb-in (17,740 Nm) |
| Maximum Speed | 1,750 RPM |
| Air Actuation | Air tube type |
| Dimension Item | Reference / Action |
|---|---|
| Bore Range | Confirm existing shaft diameter and keyway dimensions |
| Driving Ring Bolt Pattern | Measure adapter bolt circle |
| Overall Diameter | 18 in nominal; confirm clearance |
The 218 uses two friction discs for higher torque capacity. Air inflates the tube to clamp the plates. Release springs disengage the clutch when air is exhausted.
Replacing a Power Grip 218? Verify:
Commonly used on drawworks main drum drives.
Internal links:
Suitable for heavier drawworks drum engagement.
Not intended for: continuous slip braking.
Not sure whether the 118, 218, or 318 is correct? Send HYRIG the nameplate photo and shaft dimensions.
Q: What is the difference between 118 and 218?
The 118 has 1 plate; the 218 has 2 plates. The 218 provides approximately double the static torque.
Q: What is the lead time?
Standard lead time is quoted per order based on configuration; confirm with HYRIG at inquiry.
Q: Can I buy wear components separately?
Friction discs and air tubes are available; verify part numbers against your drawing.
For 218 clutch selection, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.