HYRIG can supply the XBSY SB series solid control sand pumps range and its spare parts. The XBSY SB series sand pump is an axial suction pump used as solid control equipment for transferring drilling fluids with suspended particles.
Working Principle
The pump uses an axial suction structure. The impeller rotates to generate centrifugal force, transferring the drilling fluid from the suction inlet to the discharge outlet. The shaft seal uses a mechanical seal as the primary seal and packing as the auxiliary seal.
Installation Requirements
- The pump should be installed as close to the liquid source as possible to shorten the suction line.
- The foundation must be horizontal and rigid to avoid vibration.
- The suction pipeline should be straight and at least twice the diameter of the inlet.
- Do not use the pump to support the weight of the pipelines.
- For belt-driven pumps, ensure proper belt tension and alignment.
Selection Guide
- SB6×8: Recommended for drilling rigs over 3200 m.
- SB5×6: Recommended for drilling rigs below 2500 m.
- SB4×5, SB3×4, SB2×3: Used for smaller flow rates or auxiliary transfer.
- Choose forward (Z) or reverse (F) rotation based on the pipeline layout.
- Choose coupling-driven (default) or belt-driven (P) based on site conditions.
Related Pages
Contact
For XBSY sand pump selection and installation support, contact HYRIG: info@hyrig.com