XBSY SB6×8J Sand Pump | Drilling Fluid Transfer Pump
Overview:
The XBSY SB6×8J is a forward-rotation, coupling-driven solid control sand pump used for drilling fluid transfer in oil and gas operations. It features axial suction, wear-resistant cast iron flow parts, and a mechanical seal with packing auxiliary. The 75 kW version delivers up to 240 m³/h flow and 37 m head at 1480 rpm. HYRIG can supply the XBSY SB series range and matching spare parts.
The XBSY SB6×8J uses an axial suction structure. The impeller is mounted on a shaft supported by two bearings. The shaft seal consists of a primary mechanical seal with hard alloy faces and an auxiliary packing seal. The mechanical seal is the main sealing element; the packing should only be tightened after the mechanical seal fails. The pump must be filled with liquid before startup. No-load running must not exceed 5 seconds.
| Model | Motor Power | Rotation | Drive | Typical Use |
|---|---|---|---|---|
| SB6×8J-12 | 45 kW | Forward | Coupling | Drilling rigs over 3200 m |
| SB6×8J-12.5 | 55 kW | Forward | Coupling | Drilling rigs over 3200 m |
| SB6×8J-13 | 75 kW | Forward | Coupling | Drilling rigs over 3200 m |
| SB6×8FJ-13 | 75 kW | Reverse | Coupling | Reverse layout |
| SB6×8JP-13 | 75 kW | Forward | Belt | Belt-driven setup |
Data source: Technical data table
The XBSY SB6×8J pump head contains replaceable components including pump case, impeller, mechanical seal, shaft sleeve, bearings, oil seals, and packing. For the complete parts list and exploded view, see the XBSY SB6×8J sand pump parts page.
Specifications:
FAQ:
Contact Us:
For XBSY SB6×8J sand pump selection and spare parts, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.