HYRIG can supply the Z23Y series union mud gate valve range and its replacement parts. The Z23Y-126-35F is a manual, rising-stem gate valve with a 5" (DN126) bore, engineered for large-volume abrasive drilling mud service at pressures up to 5,000 psi (35 MPa). It features a standard FIG1003 hammer union connection and a precision-lapped metal-to-metal (hard) seal for reliable shut-off in high-pressure manifolds.
| Model Number | Nominal Diameter | Working Pressure | L (Length) | H (Height) | A (Width) | End Connection |
|---|---|---|---|---|---|---|
| Z23Y-126-35F | 126 mm (5") | 35 MPa (5,000 psi) | 497 mm | 924.5 mm | 186.5 mm | FIG1003 |
Data source: Technical data table.
Looking for smaller sizes? Explore the full Z23Y Union Mud Valve Series.
Based on the standard Z23Y series design, the exact footprint for the Z23Y-126-35F is:
These dimensions are critical for replacing existing valves in confined manifold spaces. Verify your current L-dimension before ordering.
The Z23Y series utilizes a parallel metal-to-metal sealing design (indicated by the "Y" in the model code). The solid slab gate is sandwiched between two floating seat rings. When the valve is closed, line pressure pushes the downstream seat against the gate, creating a hard seal. The hard-faced metal seats provide drop-in reliability and survive pressure spikes and abrasive cuttings.
Replacing an older large-bore hammer union mud valve? Here is what to verify:
The Z23Y-126-35F is specifically suited for:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure if this 5-inch valve fits your manifold? Our engineers can help. Tell us your manifold working pressure and line size, and we will verify the correct Z23Y model.
We supply replacement parts for the Z23Y-126 series, including gate and seat assemblies, stem packing kits, and handwheels. See our Z23Y Mud Valve Parts page for compatible repair kits.
Q: What is the maximum pressure for the Z23Y-126-35F?
A: The maximum working pressure is 35 MPa (5,000 psi).
Q: What is the face-to-face length of this specific valve?
A: The overall length (L) from end to end is 497 mm.
Q: Does this valve use metal-to-metal sealing?
A: Yes. The "Y" in Z23Y indicates a hard metal-to-metal seal designed for abrasive mud.
Q: What is the typical lead time?
A: Standard lead time is 30-35 days due to the large size. Contact us for expedited options.
For Z23Y-126-35F mud gate valve selection and replacement parts, contact HYRIG: info@hyrig.com
Page last updated: 2026-11-08
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.