HYRIG can supply the 4-inch 3000 psi soft seal mud gate valve and its replacement parts. This manual, rising-stem gate valve features a 4" (DN100) bore and a rubber seat (soft seal) design, engineered for standard drilling mud service at pressures up to 3,000 psi (21 MPa). It is available with LCSG, LP, BW, or RJ end connections for versatile manifold integration.
| Size & Pressure | Nominal Diameter | Pressure (MPa) | L (mm) | H (mm) | Available Connections |
|---|---|---|---|---|---|
| 4in 5000 psi | 100 mm | 35 MPa | 330 mm | 740 mm | LCSG / LP / BW / RJ |
| 4in 3000 psi | 100 mm | 21 MPa | 330 mm | 590 mm | LCSG / LP / BW / RJ |
| 4in 1000 psi | 100 mm | 7 MPa | 300 mm | 422 mm | LCSG / LP / BW / RJ |
Data source: Technical data table.
Need a higher pressure rating? View the 4in 5000 psi Soft Seal Mud Valve or explore the full Soft Seal Mud Valve Series.
The exact footprint for the 4-inch 3000 psi configuration is:
Note: While the face-to-face length is the same as the 5000 psi model, the overall height is shorter (590 mm vs 740 mm). Verify your pipe cut-out length and overhead clearance before ordering.
This valve utilizes a soft seal (rubber seat) design, providing a tight shut-off with lower operating torque. The 3,000 psi rating is ideal for standard mud manifolds.
You can select the end connection based on your manifold design: LCSG/LP for threaded pipes, BW for permanent welding, and RJ for flanged connections.
Replacing an older 4-inch mud valve? Here is what to verify:
This configuration is specifically suited for:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure which end connection (LCSG, LP, BW, RJ) is right for your system? Our engineers can help. Tell us your pipe specifications, and we will verify the correct configuration.
We supply replacement parts for this model, including rubber seats, gates, and stem packing kits. See our Mud Valve Parts page for compatible repair kits.
Q: What is the face-to-face length of this valve?
A: The overall length (L) is 330 mm.
Q: What is the difference between this and the 5000 psi model?
A: The face-to-face length (L) is the same (330 mm), but the pressure rating is lower (21 MPa vs 35 MPa) and the overall height is shorter (590 mm vs 740 mm).
Q: Is this a soft seal or hard seal valve?
A: This series utilizes a soft seal (rubber seat) design.
Q: What is the typical lead time?
A: Standard lead time is 20-25 days. Contact us for expedited options.
For 4-inch 3000 psi soft seal mud gate valve selection, contact HYRIG: info@hyrig.com
Page last updated: 2026-11-08
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.