HYRIG can supply the 4-inch 1000 psi soft seal mud gate valve and its replacement parts. This manual, rising-stem gate valve features a 4" (DN100) bore and a rubber seat (soft seal) design, engineered for low-pressure drilling mud service at pressures up to 1,000 psi (7 MPa). It is available with LCSG, LP, BW, or RJ end connections for versatile manifold integration.
| Size & Pressure | Nominal Diameter | Pressure (MPa) | L (mm) | H (mm) | Available Connections |
|---|---|---|---|---|---|
| 4in 5000 psi | 100 mm | 35 MPa | 330 mm | 740 mm | LCSG / LP / BW / RJ |
| 4in 3000 psi | 100 mm | 21 MPa | 330 mm | 590 mm | LCSG / LP / BW / RJ |
| 4in 1000 psi | 100 mm | 7 MPa | 300 mm | 422 mm | LCSG / LP / BW / RJ |
Data source: Technical data table.
Need a higher pressure rating? View the 4in 3000 psi Soft Seal Mud Valve or explore the full Soft Seal Mud Valve Series.
The exact footprint for the 4-inch 1000 psi configuration is:
Note: This low-pressure model has a shorter face-to-face length (300 mm) compared to the 3000/5000 psi models (330 mm). Verify your pipe cut-out length before ordering.
This valve utilizes a soft seal (rubber seat) design, providing a tight shut-off with lower operating torque. The 1,000 psi rating and compact dimensions make it ideal for low-pressure mud circulation and mixing lines.
You can select the end connection based on your manifold design: LCSG/LP for threaded pipes, BW for permanent welding, and RJ for flanged connections.
Replacing an older 4-inch low-pressure mud valve? Here is what to verify:
This configuration is specifically suited for:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure if the 1000 psi rating is sufficient for your line? Our engineers can help. Tell us your manifold working pressure and pipe specifications, and we will verify the correct configuration.
We supply replacement parts for this model, including rubber seats, gates, and stem packing kits. See our Mud Valve Parts page for compatible repair kits.
Q: What is the face-to-face length of this valve?
A: The overall length (L) is 300 mm.
Q: Is the length different from the higher pressure models?
A: Yes. The 1000 psi model is shorter (300 mm) compared to the 3000/5000 psi models (330 mm).
Q: Is this a soft seal or hard seal valve?
A: This series utilizes a soft seal (rubber seat) design.
Q: What is the typical lead time?
A: Standard lead time is 15-20 days. Contact us for expedited options.
For 4-inch 1000 psi soft seal mud gate valve selection, contact HYRIG: info@hyrig.com
Page last updated: 2026-11-08
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.