HYRIG can supply the Cameron Type QRC ram BOP seal range and its spare parts. The rear seal is a critical elastomer component for 10" 3,000 psi Type QRC ram BOPs, providing a pressure barrier at the rear of the ram cavity.
| Parameter | Detail |
|---|---|
| Component Type | Rear Seal |
| Equipment Type | Cameron Type QRC Ram BOP |
| BOP Size | 10" |
| Working Pressure | 3,000 psi |
| Material | NBR (Nitrile Rubber) |
| API Standard | API 16A |
Data source: Technical data table and official specifications.
| Parameter | Detail |
|---|---|
| Seal Type | Rear Seal |
| Assembly Position | Rear of ram cavity |
| Weight | Not specified; confirm with supplier |
The rear seal is installed at the back of the ram cavity in a Cameron Type QRC BOP. It prevents wellbore pressure from escaping past the rear of the ram assembly. The QRC (Quick Ram Change) design facilitates rapid seal replacement, minimizing downtime. This seal should be inspected and replaced during ram change-out or major overhauls.
When replacing the rear seal, it is recommended to inspect the ram packers at the same time.
Related Components:
To ensure you receive the exact rear seal for your 10" 3,000 psi QRC BOP, please provide your BOP serial number and model. HYRIG will confirm the correct part number.
Suitable for Cameron Type QRC ram BOPs (10" 3,000 psi) during ram maintenance or major overhauls.
HYRIG provides replacement rear seals and ram packers for Cameron Type QRC BOPs.
What is the part number for the 10" QRC rear seal?
The part number depends on the specific QRC BOP variant. Please contact HYRIG with your BOP serial number to confirm the exact part number.
When should the rear seal be replaced?
It is best practice to replace it every time the rams are changed or during major overhauls to prevent pressure leaks.
What material is this seal made of?
It is made of NBR (Nitrile Rubber) for standard service. HNBR is available for H2S or high-temp.
*Disclaimer: This equipment is designed for high-pressure and hazardous well control applications. Ensure strict compliance with local safety standards and verify pressure ratings and API certifications prior to installation.*
HYRIG is a China-based manufacturer and global supplier of well control equipment and elastomer spare parts. We can supply the rear seal for Cameron 10" QRC BOPs. For selection support, contact HYRIG: info@hyrig.com
Page last updated: 2026-10-28
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.