DIN 3840 Swing Check Valve FAQ | PN, Face-to-Face & Installation

2026-11-17 18:59

DIN 3840 Swing Check Valve FAQ

HYRIG can supply DIN 3840 swing check valves. This FAQ addresses common engineering and procurement questions regarding PN ratings, DIN 3202 face-to-face series, installation, and testing.

Frequently Asked Questions

Q: What is the difference between DIN 3202 F1 and F2?

F1 is the shorter series used for PN16 and some PN40 sizes; F2 is longer and used for PN25/40 at larger sizes. They are not dimensionally interchangeable.

Q: Can I use a PN40 valve to replace a PN16 valve with the same DN?

Not without checking the face-to-face series. A PN40 F2 valve is longer than a PN16 F6 valve of the same DN and will not fit the same piping gap.

Q: Can a DIN swing check valve be installed vertically?

Some configurations accept vertical upward flow, but the disc must close by gravity. Confirm the orientation and minimum flow with the manufacturer.

Q: What happens if the valve is installed in a vertical downward-flow line?

The disc cannot close against the flow direction, and the valve will not function as a check valve.

Q: What testing standards apply to DIN swing check valves?

Standard testing is to DIN 3230 and EN 12266-1. API 598 testing can be provided as an option.

Q: What is the typical lead time?

Standard lead time is 4–6 weeks depending on size, PN rating, material, and documentation.

Q: Are material certificates provided?

Yes. EN 10204 3.1 material certificates for the body and trim can be provided upon request.

Q: Can the valve be supplied with a damped or counterweighted disc?

Yes. Damped and counterweighted designs are available for large pump discharge lines where water hammer risk is a concern.

Selection Support

For specific questions regarding your DIN swing check valve installation or selection, provide the DN, PN rating, existing piping gap, medium, and flow conditions. Our engineering team will confirm the DIN 3202 series and valve configuration.

Contact

For more information on DIN 3840 swing check valves, contact HYRIG: info@hyrig.com

Related Pages

Name:
Message:
Verification code:
Submit
Comment