HYRIG can supply Y-strainers to both DIN and ASME standards. This guide explains why the two standards are not drop-in equivalents, covering face-to-face lengths, flange drilling, and pressure-rating methods.
| Feature | DIN Y-Strainer | ASME Y-Strainer |
|---|---|---|
| Pressure system | PN (nominal pressure) | Class (pressure-temperature tables) |
| Units | Metric (mm, bar) | Inch-pound (in, psi) |
| Face-to-face | DIN 3202 F1 | ASME B16.10 |
| Flange drilling | EN 1092-1 / DIN 2543–2551 | ASME B16.5 |
| Typical market | Europe, metric-spec projects | Oil and gas, worldwide |
| Dimension | Standard |
|---|---|
| DIN face-to-face | DIN 3202 F1 |
| ASME face-to-face | ASME B16.10 |
| DIN flange | EN 1092-1 / DIN 2543–2551 |
| ASME flange | ASME B16.5 |
DIN and ASME Y-strainers share the same functional geometry: an angled screen chamber that captures debris. The difference is the dimensional and documentation framework.
DIN 3202 defines the face-to-face length in the PN system, with metric flange drilling per EN 1092-1. ASME B16.10 defines the face-to-face length in the Class system, with imperial flange drilling per ASME B16.5. At the same nominal size (e.g., DN 100 vs NPS 4), the OD, bolt circle, and face-to-face length differ. The two are not dimensionally interchangeable.
In practice, this means a DIN Y-strainer cannot replace an ASME Y-strainer without checking the piping gap and the mating flange. A spool piece or flange adapter may be required.
When replacing a DIN Y-strainer with an ASME Y-strainer, or vice versa:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Q: Can a DIN Y-strainer replace an ASME Y-strainer?
No. The face-to-face length, flange drilling, and pressure rating system differ. A substitution requires a full dimensional check.
Q: Is DN 100 the same as NPS 4?
DN 100 and NPS 4 are similar nominal sizes, but the flange dimensions, bolt pattern, and face-to-face length are not interchangeable.
Q: Which standard is used in Europe?
DIN 3202 and EN 1092-1 are the European standards for Y-strainers. ASME B16.10 and B16.5 are used in the Americas and in many international oil and gas projects.
Q: What is the typical lead time?
Standard lead time is 4–6 weeks depending on size, PN rating, material, and documentation.
To confirm the correct standard basis and face-to-face series for your line, provide the DN, PN/Class rating, existing piping gap, and flange drilling. Our engineers will verify the specification.
For DIN vs ASME Y-strainer selection, contact HYRIG: info@hyrig.com