HYRIG can supply the FESTO SME-8 reed proximity sensor range and its variants. The SME-8 series is a reed-type sensor for T-slot cylinders, with a normally-open contact output and a 2.5 m cable. It is used to detect the piston position in T-slot cylinders where a simple contact closure is preferred over a PNP/NPN solid-state output, and the passive reed contact is tolerant of electrical noise.
| Series | SME-8, reed proximity sensor |
| Mounting | T-slot |
| Output function | Normally open (N/O) contact |
| Operating voltage | 12 VDC … 30 VDC |
| Electrical connection | 2.5 m cable |
| Protection class | IP65 / IP67 |
| Operating temperature | -40 °C … +85 °C |
| Model | Output | Connection | Cable length | Protection class |
|---|---|---|---|---|
| SME-8-K-LED-24 | N/O contact | Cable | 2.5 m | IP65 / IP67 |
| SME-8M-DS-24V-K-2,5-OE | N/O bipolar contact | Open end | 2.5 m | IP65 / IP68 |
Data source: Technical data table.
The SME-8 is a reed-type sensor that uses a glass-encapsulated reed switch actuated by the magnetic field of the piston magnet. When the piston magnet approaches the sensor, the reed contacts close, completing the circuit. The LED indicator shows the switching status, which helps during commissioning and troubleshooting.
The 2.5 m cable is long enough to reach a terminal box or a PLC input module without an intermediate connector. The IP65/IP67 protection class covers dust and water jets, making the sensor suitable for machine-tool and washdown-adjacent environments. Unlike a magnetoresistive sensor, the reed sensor has no active electronics in the sensing head, so it is tolerant of electrical noise — but the contact life is finite, and the switching frequency is lower than a solid-state sensor.
Start with the PLC input type: the SME-8 provides a contact closure, so it can be wired to either a sinking or sourcing input. If the PLC requires a solid-state PNP or NPN signal, choose the SMT-8M magnetoresistive sensor instead. Next, confirm the cable length: the standard 2.5 m cable reaches most terminal boxes; for longer runs, an extension cable is required. Finally, confirm the switching frequency: the reed contact has a finite life and a lower maximum frequency than a solid-state sensor; for high-cycle applications, the SMT-8M is preferred.
Q: What is the output type of the Festo SME-8?
A: Normally open (N/O) contact, with a 12-30 VDC operating voltage range.
Q: What is the cable length of the SME-8-K-LED-24?
A: 2.5 m, which allows direct connection to a terminal box without an intermediate connector.
Q: What is the difference between SME-8 and SMT-8M?
A: SME-8 is a reed-type sensor with a contact output; SMT-8M is a magnetoresistive sensor with a solid-state PNP or NPN output.
Q: What is the protection class of the SME-8-K-LED-24?
A: IP65 / IP67, covering dust and water jets for machine-tool and washdown-adjacent environments.
Q: What is the lead time for Festo SME-8 sensors?
A: Standard lead time is 7-17 days from order confirmation, based on the quoted supply status. Some base models are discontinued; confirm availability before ordering.
For FESTO SME-8 sensor selection and cable configuration, contact HYRIG: info@hyrig.com.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.