Elevator Bore Charts Guide | Sizing & Replacement Reference

2026-11-10 16:20

Elevator Bore Charts Guide | Sizing & Replacement Reference

This reference guide provides sizing information and bore chart logic for standard elevators. Proper elevator selection reduces the risk of dropped pipe incidents.

NOV is a registered trademark of National Oilwell Varco. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by National Oilwell Varco.

Why Elevator Bore Sizing Matters

A high percentage of dropped pipe incidents are related to selecting the wrong pipe size and/or elevator bore size. The elevator bore ID must match the tool joint OD, while the pipe body OD must clear the elevator opening.

How to Measure Elevator Bore (ID)

  1. Insert a bore measurement tool (e.g., BoreMatch) into the elevator bore.
  2. Spread the tool legs until the outer tips make contact with the bore.
  3. Read the ID measurement directly from the scale.

Standard Bore Chart Ranges

The following table summarizes the bore code ranges used for standard elevators.

Pipe TypeStandard Bore Code RangeKey Sizing Note
Casing16 in. to 36 in.Verify casing coupling OD
Tubing2⅜ in. to 4½ in.Match tool joint OD
Drill Pipe2⅜ in. to 6⅝ in.Verify tool joint and pipe body OD
Drill Collar4 in. to 11¼ in.Verify slip recess dimensions

Data source: Technical data and parts list.

Cross-Reference & Replacement

Replacing an elevator? Check these points before ordering:

  1. Pipe Body OD: Measure the pipe body to ensure it clears the elevator opening.
  2. Tool Joint OD: Measure the tool joint OD to match the elevator bore ID.
  3. Elevator Type: Confirm the elevator model and series.

Explore Compatible Elevator Replacements

Frequently Asked Questions

Q: What happens if the elevator bore is too large?
A: An oversized bore can allow the tool joint to slip through, leading to dropped pipe incidents.

Q: How accurate are manual bore measurements?
A: Manual tools like BoreMatch are typically accurate up to 1/16 inch or 1.5 mm.

Q: Do HYRIG compatible elevators use the same bore codes?
A: Compatible replacements are dimensionally matched to standard API bore charts. Always verify with our engineers before ordering.

Contact

Need help identifying your elevator bore? Contact HYRIG: info@hyrig.com

NOV is a registered trademark of National Oilwell Varco. HYRIG is an independent supplier of compatible replacement products and is not affiliated with, authorized by, or endorsed by National Oilwell Varco.

Related Pages

Name:
Message:
Verification code:
Submit
Comment