HYRIG can supply the TSC HA series drilling fluid mixers range and its spare parts. This page provides answers to frequently asked questions about the operation and maintenance of the TSC HA series mixers.
Q1: What is the correct rotation direction of the impeller?
A: Viewed from the top, the impeller should rotate clockwise. Check the direction indicator on the coupling guard.
Q2: Can the mixer run without mud?
A: No. The impeller must be inserted below the liquid level. Running dry or with entangled materials is prohibited.
Q3: What is the first oil change interval for the reducer?
A: Change the gear oil after the first 100 hours of operation to flush out break-in particles. After that, change every 3 months.
Q4: What is the maximum allowed mud specific gravity?
A: The required mud specific gravity is less than 2.4 g/cm³.
Q5: What should I do if the mixer vibrates or makes abnormal noise?
A: Immediately shut off the power supply. Check for loose foundation bolts, bearing wear, or impeller entanglement. Replace worn parts if necessary.
Q6: What is the maximum operating temperature for the reducer?
A: The oil temperature in the reducer can reach up to 95°C under normal operation. If it exceeds this, stop the machine and check for overload or oil issues.
Q7: Does HYRIG supply TSC HA mixer spare parts?
A: Yes. HYRIG supplies the TSC HA series mixers and matching spare parts, including shaft assemblies, impellers, elastic blocks, bearings, and oil seals.
For TSC drilling fluid mixer technical support and spare parts, contact HYRIG: info@hyrig.com