HYRIG can supply BS EN 1092-1 flanges. Because the standard defines multiple types, face forms, and materials, an incomplete RFQ often leads to mismatched bolt circles, incorrect gasket selection, or non-compliant materials. The RFQ must include the six core attributes.
To receive a correctly machined flange, provide the following data in your RFQ:
| Data Field | Why It Is Needed |
|---|---|
| Standard | Confirms the dimensional and pressure-rating system (EN 1092-1). |
| Nominal Size (DN) | Defines the bore and flange OD. |
| Pressure Rating (PN) | Determines the flange thickness, bolt size, and face form. |
| Flange Type | Specify Type 11 (weld neck) or Type 01 (plate). |
| Face Form | Specify Form A (flat face) or Form B (raised face). |
| Material Grade | Specify EN material (P250GH, 1.4306, 1.4404) or equivalent. |
| Documentation | State if EN 10204 3.1 material certificates are required. |
| Dimension | Standard |
|---|---|
| Flange OD (D) | EN 1092-1 |
| Bolt Circle (k) | EN 1092-1 |
| Bolt Hole (d2) | Metric, EN 1092-1 |
The most common RFQ error is specifying the DN and PN but omitting the flange type and face form. A DN100 PN16 flange can be a Type 11 weld neck or a Type 01 plate, and it can have a Form A flat face or a Form B raised face. These are not interchangeable.
Another frequent error is mixing standards. An RFQ that says "DN100 PN16, 150# bolt pattern" will confuse the supplier and likely result in a non-compliant part. EN 1092-1 uses metric bolt sizes (M16, M20) and metric bolt circles. Do not mix ASME bolt patterns with EN flange dimensions.
When ordering replacement flanges:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Q: What is the most important field in an EN 1092-1 RFQ?
The flange type and face form. DN and PN alone do not define the full geometry or the gasket requirement.
Q: Can I specify "weld neck" instead of Type 11?
You can, but Type 11 is the precise EN 1092-1 designation. Using the type number reduces ambiguity.
Q: Do I need to specify the bolt size?
Yes, if the flange is supplied with bolts. EN 1092-1 uses metric bolts (M16, M20, etc.). Specify if you need bolts included.
Q: What is the typical lead time?
Standard lead time is 4-6 weeks depending on size, PN rating, material, and documentation.
To ensure the flange matches your pipeline, provide the DN, PN rating, type, face form, and material. Our engineering team will verify the specification against EN 1092-1.
For EN 1092-1 flange RFQ support, contact HYRIG: info@hyrig.com