HYRIG can supply BS EN 1092-1 flanges. This FAQ addresses common engineering and procurement questions regarding PN ratings, flange types, face forms, and installation.
Q: Can a PN16 flange be bolted to a Class 150 flange?
No. The bolt circle, bolt hole diameter, and bolt thread differ between EN 1092-1 and ASME B16.5. They cannot be bolted together.
Q: Does PN16 mean 16 bar at all temperatures?
No. PN16 is a nominal pressure reference. The allowable pressure decreases as temperature increases. For carbon steel at 200°C, PN16 is rated at about 13.3 bar.
Q: What is the difference between Type 11 and Type 01?
Type 11 is a weld-neck flange with a tapered hub for high-pressure service. Type 01 is a plate flange for lower-pressure, less severe service.
Q: What is the difference between Form A and Form B?
Form A is a flat face requiring a full-face gasket. Form B is a raised face used with spiral wound or confined gaskets.
Q: Can I mate Form A with Form B?
No. The raised face of Form B will not seal correctly against the flat face of Form A.
Q: What material grades are available?
Standard grades include P250GH (carbon steel), 1.4306 (304L), and 1.4404 (316L). Other grades are available on request.
Q: Are EN 10204 3.1 material certificates provided?
Yes. Certificates can be provided upon request for the flange body.
Q: What is the typical lead time?
Standard lead time is 4-6 weeks depending on size, PN rating, material, and documentation.
For specific questions regarding your EN 1092-1 flange installation or selection, provide the DN, PN rating, type, face form, and material. Our engineering team will confirm the specification.
For more information on BS EN 1092-1 flanges, contact HYRIG: info@hyrig.com