HYRIG can supply the FESTO VMPA valve terminal range and its variants. The VMPA series is a compact valve terminal platform with 10 mm and 14 mm valve widths, used where the terminal must fit into a small control cabinet or a machine frame with limited space. It includes 2x3/2 normally closed monostable, 5/2 monostable, and 5/2 bistable functions, with flow rates up to 230 l/min for the 10 mm width.
| Series | VMPA, compact valve terminal |
| Valve widths | 10 mm, 14 mm |
| Functions | 2x3/2 NC monostable, 5/2 monostable, 5/2 bistable |
| Flow rate | 230 l/min (10 mm width) |
| Operating pressure | 3 bar … 10 bar |
| Operating voltage | 24 VDC |
| Protection class | IP65 |
| Model | Function | Flow rate | Valve size | Pressure range | Order code |
|---|---|---|---|---|---|
| VMPA1-M1H-K-PI | 2x3/2 NC monostable | 230 l/min | 10 mm | 3-10 bar | 533347 |
Data source: Technical data table.
The VMPA1-M1H-K-PI is a 2x3/2 normally closed monostable valve. Each 3/2 section has its own solenoid and pneumatic spring; when energized, the section opens to supply the corresponding actuator port; when de-energized, the spring returns the spool and the port exhausts. The two sections operate independently, so one slice can control two separate single-acting cylinders or two pilot ports on a larger valve.
The 10 mm valve width is the narrowest VMPA1 slice, used where the valve terminal must fit into a compact control cabinet. The standard nominal flow rate is 230 l/min with QS-6 fittings. The soft sealing principle provides tighter shut-off than a hard-sealed spool valve. The operating pressure range is 3-10 bar, and the pilot pressure is 3-8 bar. Note that the valve is not suitable for vacuum.
Start with the function: 2x3/2 for two single-acting actuators or two independent on/off functions; 5/2 for a double-acting cylinder. Next, confirm the valve width: 10 mm for compact cabinets, 14 mm for higher flow. Finally, confirm the operating pressure: 3-10 bar; if the supply can drop below 3 bar, the VMPA may not operate reliably — consider a different valve series.
Q: What is the flow rate of the Festo VMPA1-M1H-K-PI?
A: 230 l/min standard nominal flow rate with QS-6 fittings, per 3/2 section.
Q: What is the difference between 2x3/2 and 5/2 valve functions?
A: A 2x3/2 valve contains two independent 3/2 sections for two single-acting actuators. A 5/2 valve is a single spool for a double-acting cylinder.
Q: Can the VMPA1-M1H-K-PI be used for vacuum?
A: No. The valve is not suitable for vacuum. If the application requires vacuum control, choose a different valve series.
Q: What is the product weight of the VMPA1-M1H-K-PI?
A: 56 g, based on the valve body without manifold accessories.
Q: What is the lead time for Festo VMPA valve terminals?
A: Standard lead time is 7-17 days from order confirmation, based on the quoted supply status.
For FESTO VMPA valve terminal selection and manifold configuration, contact HYRIG: info@hyrig.com.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.