HYRIG can supply the FESTO CPX terminal I/O module range and its variants. The CPX terminal is a modular valve and I/O platform; the I/O modules add digital inputs and outputs to the terminal so that sensors and switches can be connected directly. This overview covers the CPX-8DE digital input module and the module selection points for a CPX terminal.
| Series | CPX, terminal I/O module |
| Module type | Digital input module |
| Example model | CPX-8DE, 8 inputs, PNP, 24 VDC |
| Switching logic | PNP (positive switching) |
| Operating voltage | 18 VDC … 30 VDC |
| Max. total input current | 1 A per module |
| Protection class | IP20 (depends on connection block) |
| Model | Inputs | Switching logic | Max. current per module | Order code |
|---|---|---|---|---|
| CPX-8DE | 8 | PNP | 1 A | 195750 |
| CPX-4DE | 4 | PNP | 0.7 A | — |
| CPX-8DE-D | 8 | PNP (channel diagnostics) | 0.7 A | — |
Data source: Technical data table.
The CPX-8DE is a digital input module for the CPX terminal. It provides 8 PNP input channels, each of which reads a 24 VDC signal from a sensor or switch. The switching level is defined as signal 0 ≤ 5 V and signal 1 ≥ 11 V, which provides noise immunity for industrial environments. The input filter time is 3 ms by default but can be parameterised to 0.1, 3, 10, or 20 ms to match the sensor response time or to suppress contact bounce.
The module is mounted on the CPX terminal backplane and communicates with the terminal controller via the internal bus. The maximum total input current per module is 1 A, which limits the number of sensors that can be powered from the module. The IP20 protection class means the module must be installed inside a control cabinet or a protected enclosure.
Start with the sensor output type: the CPX-8DE is a PNP input module, so the sensors must also be PNP (positive switching). If the sensors are NPN, a different input module or an interface is required. Next, confirm the channel count: the CPX-8DE provides 8 inputs; for fewer channels, the CPX-4DE or a different terminal configuration may be more economical. Finally, confirm the total current: the 1 A per module limit covers most proximity sensors, but if many sensors are connected, check the total current draw.
Q: How many inputs does the Festo CPX-8DE have?
A: 8 digital inputs, with PNP (positive switching) logic and IEC 1131-T2 input characteristic.
Q: What is the operating voltage range of the CPX-8DE?
A: 18 VDC to 30 VDC, with a nominal voltage of 24 VDC.
Q: What is the maximum total input current per module?
A: 1 A. Confirm that the total current draw of all sensors connected to the module does not exceed this limit.
Q: Can the input filter time be adjusted?
A: Yes. The default filter time is 3 ms, and it can be parameterised to 0.1, 3, 10, or 20 ms.
Q: What is the protection class of the CPX-8DE?
A: IP20, which means the module must be installed inside a control cabinet or a protected enclosure.
For FESTO CPX I/O module selection and CPX terminal configuration, contact HYRIG: info@hyrig.com.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.