HYRIG can supply the FESTO DFSP stopper cylinder range and its variants. The DFSP series is a single-acting pulling stopper cylinder with elastic end-position cushioning and a built-in magnet for position sensing. It is used on conveyor and roller lines to block, separate, or position workpieces. The 20 mm bore covers light-duty lines, and the 50 mm bore covers heavier workpieces with a 6280 N impact force.
| Series | DFSP, stopper cylinder |
| Mode of operation | Single-acting, pulling |
| Bore range | 20 mm, 50 mm |
| Stroke range | 15 mm, 30 mm |
| Operating pressure | 1.2 bar … 10 bar |
| Cushioning | P-A elastic, both ends |
| Position sensing | Built-in magnet for proximity switch |
| Max. impact force | 6280 N (50 mm bore) |
| Model | Bore | Stroke | Impact force | Lateral force | Weight | Order code |
|---|---|---|---|---|---|---|
| DFSP-20-15-PS-PA | 20 mm | 15 mm | 1370 N | 228 N | 0.22 kg | 576079 |
| DFSP-50-30-PS-PA | 50 mm | 30 mm | 6280 N | 1570 N | 1.2 kg | 576152 |
Data source: Technical data table.
The DFSP series is a single-acting pulling stopper cylinder. Compressed air enters the port and retracts the piston rod, pulling the stopper lever or gate out of the workpiece path. When the air is exhausted, a mechanical spring extends the rod and returns the stopper to the blocking position. The elastic cushioning at both ends absorbs the impact when the stopper extends into the path of a moving workpiece.
The 20 mm bore delivers a 1370 N impact force and tolerates 228 N lateral force during switching. The 50 mm bore delivers 6280 N impact force and tolerates 1570 N lateral force. Both variants have a built-in magnet, so the piston position can be detected with standard FESTO proximity switches.
Start with the workpiece weight and conveyor speed: the impact force must be within the cylinder rating. For light-duty conveyors with small workpieces, the 20 mm bore (1370 N) is sufficient; for heavier workpieces, choose the 50 mm bore (6280 N). Next, confirm the lateral force during switching: the stopper lever must not apply more side load than the cylinder rating (228 N for 20 mm, 1570 N for 50 mm). Finally, confirm the supply pressure: the 20 mm bore requires at least 1.6 bar; the 50 mm bore requires at least 1.2 bar.
Q: What is the impact force of the Festo DFSP-50-30-PS-PA?
A: 6280 N, which is the maximum force the stopper can withstand when a workpiece hits it.
Q: What is the permissible lateral force during switching?
A: 1570 N for the 50 mm bore, 228 N for the 20 mm bore.
Q: Is the DFSP series single-acting or double-acting?
A: Single-acting, pulling. Compressed air retracts the piston rod; a mechanical spring extends it back to the blocking position.
Q: Does the DFSP series have a built-in magnet for position sensing?
A: Yes. The cylinder is equipped with a built-in magnet, and the piston position can be detected with standard FESTO proximity switches.
Q: What is the lead time for Festo DFSP stopper cylinders?
A: Standard lead time is 7-17 days from order confirmation, based on the quoted supply status.
For FESTO DFSP stopper cylinder selection and sensor configuration, contact HYRIG: info@hyrig.com.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.