HYRIG can supply the FESTO DGPL rodless linear drive range and its variants. The DGPL series is a rodless pneumatic actuator with a recirculating ball bearing guide and a carriage that moves along the profile barrel. It delivers 295 N theoretical force at 6 bar and operates from 2 bar to 8 bar. The rodless design keeps the overall length close to the stroke length, making it suitable for long-travel applications where a piston-rod cylinder would be too long.
| Series | DGPL, rodless linear drive |
| Piston diameter | 25 mm |
| Stroke range | 170 mm, 270 mm |
| Guide type | Recirculating ball bearing (KF) |
| Theoretical force at 6 bar | 295 N |
| Operating pressure | 2 bar … 8 bar |
| Cushioning | PPV adjustable pneumatic, both ends |
| Basic weight | 1520 g at 0 mm stroke |
| Model | Stroke | Force at 6 bar | Guide | Basic weight | Order code |
|---|---|---|---|---|---|
| DGPL-25-170-PPV-A-KF-B | 170 mm | 295 N | Recirculating ball bearing | 1520 g | 161792 |
| DGPL-25-270-PPV-A-KF-B | 270 mm | 295 N | Recirculating ball bearing | 1520 g | 161792 series |
Data source: Technical data table.
The DGPL is a rodless linear drive with a recirculating ball bearing guide. The piston inside the profile barrel is connected to an external slide carriage through a slot; the carriage runs on recirculating ball bearings along the guide rail. Because there is no piston rod, the overall length of the drive is approximately equal to the stroke plus the end caps — there is no rod extension that would double the length at full stroke.
The recirculating ball bearing guide (KF) provides high stiffness and load capacity with low friction. The permissible lateral force during switching is 147 N. The PPV adjustable pneumatic cushioning at both ends lets you tune the exhaust air near end position. The operating pressure range of 2-8 bar is narrower than a standard cylinder (0.6-12 bar), so confirm that the supply pressure is within this range before ordering.
Start with the stroke and overall length: the rodless design is the reason to choose DGPL when the stroke is long and a piston-rod cylinder would be too long for the machine. Next, confirm the supply pressure: the DGPL operates from 2 bar to 8 bar, narrower than a standard cylinder. Finally, confirm the lateral force and moment: the permissible lateral force is 147 N during switching; if the load introduces higher side forces or moments, an external guide may be required.
Q: What is the theoretical force of the Festo DGPL-25 linear drive at 6 bar?
A: 295 N, based on the 25 mm piston area.
Q: What is the operating pressure range of the DGPL series?
A: 2 bar to 8 bar, which is narrower than a standard cylinder. Confirm that the supply pressure is within this range before ordering.
Q: What is the weight at 170 mm stroke?
A: Approximately 2421 g, calculated from 1520 g basic weight plus 53 g per 10 mm stroke (17 x 53 g).
Q: Does the DGPL series have adjustable cushioning?
A: Yes. The PPV-A suffix indicates adjustable pneumatic cushioning at both ends.
Q: What is the lead time for Festo DGPL linear drives?
A: Standard lead time is 7-8 weeks from order confirmation, based on the quoted supply status.
For FESTO DGPL rodless linear drive selection and carriage accessories, contact HYRIG: info@hyrig.com.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.