HYRIG can supply the JL series choke valve range and its replacement parts. The JLK52-35 is a manual, adjustable choke valve with a 52 mm nominal bore, engineered to regulate flow and pressure in wellhead and choke manifolds. It features a needle adjusting mode and hammer union connections for quick make-up in the field.
Note: This model is produced in two dimensional variants.
| Model Number | Nominal Diameter | Pressure (MPa) | A (mm) | B (mm) | Connection Type | Adjusting Mode | Actuator |
|---|---|---|---|---|---|---|---|
| JLK52-35 (Variant 1) | 52 mm | 35 | 206 | 154 | Hammer unions | Needle | Manual |
| JLK52-35 (Variant 2) | 52 mm | 35 | 210 | 176 | Hammer unions | Needle | Manual |
Data source: Technical data table.
Explore the full JL Choke Valve Series.
Verify your hammer union specifications before ordering, as there are two variants:
Both variants use hammer unions, but the overall length and height differ slightly. Measure your existing piping cut-out to ensure correct fitment.
The JLK52-35 utilizes a needle adjusting mode. A tapered needle moves in and out of a seat, providing fine, precise control over the flow area. This is particularly effective for lower flow rates or where micro-adjustments are needed.
The "K" indicates it is an adjustable valve. The hammer union connections allow for rapid assembly and disassembly without special tools, ideal for temporary or frequently changed manifold setups.
Replacing an older needle choke valve? Here is what to verify:
This valve is specifically suited for:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure which variant fits your piping? Tell us your existing cut-out dimensions and thread type, and our engineers will confirm the correct JLK52-35 variant.
HYRIG provides replacement parts for the JLK52-35, including:
See our JL Choke Valve Parts page for compatible maintenance kits.
Q: What adjusting mode does the JLK52-35 use?
A: It uses a needle adjusting mode, which allows for precise flow control.
Q: Why are there two different sizes listed for the same model?
A: The table lists two variants with different A and B dimensions (206x154 mm vs 210x176 mm). You must measure your existing piping to select the correct variant.
Q: What type of connection does this valve use?
A: It uses hammer union connections.
Q: What is the working pressure of this model?
A: The maximum working pressure is 35 MPa (5,000 psi).
For JLK52-35 adjustable choke valve selection and replacement parts, contact HYRIG: info@hyrig.com
Page last updated: 2026-11-08
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.