5 1/8″ 15K Quad BOP Pipe Seal Ram | Tubing Sealing

QR code
share
WeChat
Sina Weibo
QQ
QQ space
Douban
Baidu Post Bar
copy Link
Facebook
X
LinkedIn
Pinterest
Line
Tumblr
HYRIG can supply pipe seal ram assemblies and replacement sealing components for the 5 1/8″ 15,000 psi Quad BOP.
Conatct For Details
DetailReview(0)Additional

Key Facts

  • Ram position: bottom set
  • Function: seal around tubing
  • Working pressure: 15,000 psi
  • Service: H2S, NACE MR0175
  • Equalizer: required at sealing ram position
  • Tubing size: confirm against ram drawing
  • Seal type: outer and inner seal arrangement
  • Data source: Technical data and parts list

Pipe Seal Ram Specifications & Component Breakdown

ComponentFunctionReplacement guidance
Pipe seal ram bodyHouses seals and fits tubingInspect sealing surface and guide slot
Outer sealPrimary seal around tubingReplace when worn or damaged
Inner sealSecondary sealReplace with outer seal as a set
Retaining screwsSecure inner sealCheck torque and thread condition

Dimensions

ParameterValue
BOP vertical bore5 1/8″
Working pressure15,000 psi max
Temperature range-20°F to +250°F
Tubing sizeConfirm against ram drawing 1117435-XXX

Structure / Working Principle

The pipe seal ram closes around tubing to isolate pressure below the BOP. It uses an outer seal and an inner seal, with the inner seal secured by screws. The ram guide slot must align with the ram guide rod. The pipe seal ram must be paired with an equalizer assembly to equalize pressure before opening. See Equalizer Guide.

Cross-Reference & Replacement

Looking to replace pipe ram seals or a pipe seal ram assembly? Check tubing size, seal orientation, guide slot alignment and equalizer compatibility. HYRIG supplies replacement seals and related wear parts. See 5 1/8″ 15K Quad BOP and Quad BOP Parts.

Applications

  • Sealing around tubing during well control
  • Isolating pressure below the BOP
  • Workover and completion with tubing in hole
  • H2S service up to 15,000 psi working pressure

Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.

Selection Support

Confirm tubing size and seal part number before ordering. Send the BOP serial number and pipe ram drawing reference for matching.

Frequently Asked Questions

Q: What is the pipe seal ram used for?
A: It seals around tubing to isolate wellbore pressure below the BOP.

Q: Does the pipe seal ram require an equalizer?
A: Yes. Sealing ram positions must use equalizer assemblies.

Q: Can pipe ram seals be replaced separately?
A: Yes. Outer and inner seals are wear components and can be replaced as a set.

Q: How is the pipe seal ram aligned?
A: The ram guide slot must align with the ram guide rod in the actuator flange.

Q: Is this an OEM catalog page?
A: No. It describes the configuration and parts documented in the operation and maintenance manual.

Contact

For pipe seal ram selection and replacement seals, contact HYRIG: info@hyrig.com

Related Pages

Comment

comment
Name
Praise degree
Message:
Upload pictures:
    total 0 Sheet,Only 5 images can be uploaded, each less than 5m.
    Verification code
    Submit