5 1/8″ 15K Quad BOP Shear Ram | Blades & Actuator

QR code
share
WeChat
Sina Weibo
QQ
QQ space
Douban
Baidu Post Bar
copy Link
Facebook
X
LinkedIn
Pinterest
Line
Tumblr
HYRIG can supply shear ram assemblies and replacement shear blades for the 5 1/8″ 15,000 psi Quad BOP.
Conatct For Details
DetailReview(0)Additional

Key Facts

  • Ram position: second set from top
  • Function: shear tubing
  • Working pressure: 15,000 psi
  • Shear actuator closing ratio: 19.25:1
  • Shear closing volume: 367 in3 per set
  • Blade screw torque: 45 ft.lbs
  • Manual locks: not for shearing
  • Data source: Technical data and parts list

Shear Ram Specifications & Component Breakdown

ComponentFunctionReplacement guidance
Shear ram bodyCarries blade and interfaces with actuatorInspect for deformation and sealing surface damage
Shear bladeCuts tubingReplace when cutting edge is worn or chipped
Blade screwsSecure blade to ramTighten to 45 ft.lbs; replace if damaged
Shear actuatorProvides high closing ratioVerify closing ratio and seal condition

Dimensions

ParameterValue
BOP vertical bore5 1/8″
Working pressure15,000 psi max
Temperature range-20°F to +250°F
Shear closing volume367 in3 per set
Shear opening volume367 in3 per set

Structure / Working Principle

The shear ram closes with a dedicated shear actuator to cut tubing. The blade is mounted to the ram body and secured by screws tightened to 45 ft.lbs. After shearing, the blind ram above can seal the wellbore. Manual locks are not intended for shearing applications, and pressure must be equalized before opening sealing rams.

Cross-Reference & Replacement

Looking to replace shear blades or a shear ram assembly? Check ram position, blade part number, screw torque and actuator type. HYRIG supplies replacement shear blades and related wear parts. See 5 1/8″ 15K Quad BOP and Quad BOP Parts.

Applications

  • Cutting tubing during well control operations
  • Emergency shear before blind ram closure
  • Workover operations requiring tubing removal
  • H2S service up to 15,000 psi working pressure

Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.

Selection Support

Confirm tubing size, blade part number and actuator type before ordering. Send the BOP serial number and shear ram drawing reference for matching.

Frequently Asked Questions

Q: What is the shear actuator closing ratio?
A: The shear actuator closing ratio is 19.25:1.

Q: What torque is used for shear blade screws?
A: Shear blade screws are tightened to 45 ft.lbs.

Q: Can manual locks be used for shearing?
A: No. Manual locks are not intended for shearing applications.

Q: Can shear blades be replaced separately?
A: Yes. Shear blades are wear components and can be replaced separately from the ram body.

Q: Is this an OEM catalog page?
A: No. It describes the configuration and parts documented in the operation and maintenance manual.

Contact

For shear ram selection and replacement blades, contact HYRIG: info@hyrig.com

Related Pages

Comment

comment
Name
Praise degree
Message:
Upload pictures:
    total 0 Sheet,Only 5 images can be uploaded, each less than 5m.
    Verification code
    Submit