| Bit Size (in) | Working OD (mm) | Connection Top | Connection Bottom |
|---|---|---|---|
| 8 1/2 | 190 | 4 1/2 IF | 4 1/2 IF |
| 12 1/4 | 238 | 6 5/8 REG | 6 5/8 REG |
| 17 1/2 | 279 | 7 5/8 REG | 7 5/8 REG |
Data source: Technical data table. Custom sizes are available based on well requirements.
| Item | Description |
|---|---|
| Sleeve OD | Working diameter of the replaceable sleeve. |
| Body OD | Inner body diameter, consistent across sleeve replacements. |
| Overall Length | Varies by bit size; confirm against BHA drawing. |
The replaceable sleeve stabilizer consists of a main body, a stabilizer sleeve, and a replaceable wear sleeve. The sleeve can be replaced when worn, extending the life of the main body. This design is particularly effective in directional wells where frequent changes in deviation and direction occur, as the sleeve minimizes fluctuation without requiring a full tool replacement.
Looking to replace a sleeve stabilizer?
Send the bit size, connection, and directional requirements; HYRIG will confirm the matching replaceable sleeve stabilizer.
Q1: What is the advantage of a replaceable sleeve stabilizer?
The wear sleeve can be replaced without replacing the entire body, reducing maintenance costs and downtime.
Q2: How do I know when to replace the sleeve?
Replace the sleeve when the working OD wears below the specified tolerance for your BHA.
Q3: What is the lead time?
Standard sizes are typically 25-35 days after drawing confirmation.
For replaceable sleeve stabilizer selection, contact HYRIG: info@hyrig.com
Please include: bit size, connection, sleeve OD requirement, and quantity.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.