| Type | Working OD Range (mm) | Key Feature | Typical Connection |
|---|---|---|---|
| Integral Spiral Blade | 152 - 660 | Single-body machined, 3 or 4 spiral blades | NC38 - 7 5/8 REG |
| Replaceable Sleeve | 190 - 279 | Replaceable wear sleeve | 4 1/2 IF - 7 5/8 REG |
| Non-Rotating | 148 - 311 | Protects casing from tool joint wear | NC31 - NC50 |
| BDW Tapered | 152 - 311 | Variable diameter for tripping clearance | NC38 - 6 5/8 REG |
| Float Valve | 75 - 110 | Integrated float valve to prevent mud backflow | 2 3/8 IF - 7 5/8 REG |
Data source: Technical data table.
| Item | Description |
|---|---|
| Working OD | Measured across the blade crest or sleeve; determines hole contact. |
| Static OD | Reduced diameter during tripping (specific to BDW tapered type). |
| Overall Length | Varies by bit size and connection; confirm against BHA drawing. |
Drilling stabilizers maintain the drill string in the center of the borehole, preventing unwanted deviation and improving hole quality. Integral stabilizers are machined from a single steel body. Replaceable sleeve stabilizers allow the wear sleeve to be replaced without replacing the entire body. Non-rotating stabilizers use a rubber or metal sleeve to prevent the tool from rotating against the casing. BDW tapered stabilizers reduce their working diameter during tripping to prevent stuck pipe in contracted holes.
Looking to replace an existing stabilizer?
Not sure which stabilizer type fits your BHA? Send the bit size, connection, and well trajectory requirements; HYRIG will confirm the matching model.
Q1: What is the difference between a near-bit and a string stabilizer?
A near-bit stabilizer sits directly above the bit for immediate trajectory control; a string stabilizer is placed further up the drill string.
Q2: How do I choose the right stabilizer size?
Match the bit size and working OD first, then confirm the connection and overall length against your BHA drawing.
Q3: What is the lead time for standard stabilizers?
Standard sizes are typically 20-30 days after drawing and connection confirmation.
Q4: Can I order replacement sleeves for stabilizers?
Replacement sleeves are available. Provide the stabilizer size and connection for matching.
For drilling stabilizer selection and technical support, contact HYRIG: info@hyrig.com
Please include for fastest quote: bit size, connection, type (integral/replaceable/non-rotating/tapered), quantity, and destination port.
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.