The XQ114/9 hydraulic power tong is designed for heavy‑duty make‑up and break‑out of tubing up to 4½" OD in workover operations. To maintain peak performance and avoid unplanned downtime, regular inspection and timely replacement of wear parts are essential. Below is the complete genuine TEDA wear parts list for the XQ114/9.
| No. | Part No. | Part Name | Specification / Standard | Remarks |
|---|---|---|---|---|
| 1 | XQ9-44 | O‑ring | 18×2.4 | Hydraulic system sealing |
| 2 | XQ9-188 | Straight grease nipple | M8×1 | Lubrication |
| 3 | XQ9-82 | Limit screw | M12×35 | Jaw carrier fixing |
| 4 | XQ9-92 | Jaw die | For 60–78 mm tubing | Common for master & backup tong |
| 5 | XQ9-93 | Jaw die | For 89–141 mm tubing | Common for master & backup tong |
| 6 | XQ9-95 | Roller shaft | — | Supports jaw roller |
| 7 | XQ9-96 | Jaw retaining pin | — | Locks jaw die in place |
| 8 | XQ9-98 | Jaw roller | — | Rolling element in jaw mechanism |
| 9 | XQ9-126 | Lower centering roller | — | Tubing centering |
| 10 | XQ9-127 | Centering roller shaft | — | Pivot for centering roller |
| 11 | XQ9-130 | Upper support plate | — | Brake mechanism |
| 12 | XQ9-133 | Lower support plate | — | Brake mechanism |
| 13 | XQ9-136 | Reversing shaft | — | Direction control (make‑up / break‑out) |
| 14 | XQ9-122 | Brake band | — | Tong braking |
| 15 | XQ9-164 | O‑ring | 36×3.5 | Hydraulic sealing |
Based on field experience, the following parts wear fastest and should be kept in your spare parts inventory:
Jaw dies (XQ9-92 for 60–78 mm, XQ9-93 for 89–141 mm) – Most frequent replacement
Brake band (XQ9-122) – Critical for braking performance
O‑rings (XQ9-44 18×2.4, XQ9-164 36×3.5) – Prevent hydraulic leaks
⚠️ Important: Always use genuine Yancheng TEDA original parts (原厂件). Non‑genuine parts may cause premature failure, safety hazards, and void warranty.
| Part Category | Typical Service Life | Replacement Indicator |
|---|---|---|
| Jaw dies | 200–500 make/break cycles | Tooth height worn >1 mm, slipping |
| Brake band | 6–12 months (depending on use) | Reduced braking torque, tong does not stop quickly |
| O‑rings / seals | 12 months or when leaks appear | Visible oil seepage, pressure drop |
| Rollers & shafts | 12–24 months | Jamming, uneven rotation, noise |
| Support plates | 24 months or as needed | Excessive wear on friction surface |
For genuine TEDA wear parts, technical support, or to request a complete spare parts kit, please contact:
info@hyrig.com
*We offer fast shipping, original factory packaging, and after‑sales support for all XQ series power tongs (XQ89/3C, XQ114/9, and others).*
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.