A2FO/A2FM Installation Guide | Mounting, Piping & Startup

2026-11-04 18:32

Key Facts

  • Preparation: Check the model code and rotation direction before installation.
  • Mounting: Ensure the coupling has no angular deviation and no axial/radial forces act on the drive shaft.
  • Piping: Use clean pipes, proper seals, and avoid mechanical stress.
  • Bleeding: Fill the pump/motor housing with oil before first startup.

1. Pre-Installation Checks

Before mounting the pump or motor, verify the model code against your order confirmation. Ensure the rotation direction (viewed from the drive shaft end) matches your prime mover. Remove all transport protection caps and plugs (they are not pressure-resistant).

2. Mounting Positions

  • A2FO Pumps: Mount below the tank (standard) or above the tank. Ensure the suction port (S) has a minimum absolute pressure of 0.8 bar.
  • A2FM/A2FE Motors: Mount below or above the tank. For "drive shaft up" positions, use the highest case drain port (T1/T2) for bleeding. Ensure the case is always filled with oil.

3. Piping and Connections

  • Pipes: Ensure all pipes and hoses are clean and free of mechanical stress. Use suitable seals for all connections.
  • Suction Line: Keep it short, straight, and airtight. Ensure the diameter is large enough to avoid pressure drop.
  • Case Drain: Connect the highest case drain port (T1/T2) to the tank. Do not install a check valve in the drain line (unless specified for above-tank mounting).

4. First Startup and Bleeding

  • Oil Filling: Fill the pump/motor housing with filtered hydraulic oil (10 μm) through the highest case drain port before starting.
  • Startup: Run the pump/motor at low speed and no load until the system is completely bled. Check the case drain for air bubbles.
  • Checking: Verify the suction pressure (for pumps) and case pressure. Perform a leak test under maximum pressure.

Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.

Selection Support

Need help with a specific installation challenge? Explore our A2FO Pumps or A2FM Motors, or contact our engineers for technical support.

Frequently Asked Questions

Q: Can I install the pump above the oil tank?
A: Yes, but the suction height must not exceed 800 mm, and the suction pressure must remain above 0.8 bar absolute. A check valve in the drain line is recommended.

Q: What happens if I don't bleed the pump before starting?
A: Trapped air can cause cavitation, excessive noise, and severe damage to the internal components. Always fill the housing before startup.

Q: Does the drive shaft need lubrication?
A: Yes, apply a permanent lubrication layer to the drive shaft to prevent friction corrosion.

Contact

For more installation support, contact HYRIG: info@hyrig.com

Related Pages

Name:
Message:
Verification code:
Submit
Comment