A2F Pump & Motor Troubleshooting | Noise, Flow & Pressure

2026-11-04 18:32

Key Facts

  • Noise: Often caused by cavitation, air in the oil, or high viscosity.
  • Low Flow/Pressure: Can be due to internal wear, wrong rotation, or pump damage.
  • Overheating: Frequently caused by incorrect oil viscosity, overpressure, or cooling failure.
  • Vibration: Check for misalignment, loose mountings, or resonance.

1. Abnormal Noise

CauseSolution
Air in the suction lineCheck pipe connections, bleed the pump, ensure the tank level is sufficient.
High oil viscosityUse the recommended viscosity oil or warm up the system.
Suction pipe diameter too smallIncrease the pipe diameter to reduce pressure drop.
Pump mechanical damage (e.g., bearing)Contact the service team for repair/replacement.

2. No Flow or Insufficient Flow

CauseSolution
Wrong rotation directionCheck the drive motor rotation and change if necessary.
Air in the systemBleed the pump and the entire hydraulic circuit.
Pump worn outCheck internal leakage; replace the pump if wear is excessive.
Suction line blockedClean the suction filter and pipes.

3. Low Pressure

CauseSolution
Pressure valve setting too lowAdjust the relief valve or pressure control valve.
Internal leakage (wear)Check the case drain flow; if it exceeds the limit, the pump/motor needs repair.
Drive power insufficientCheck the electric motor or engine output.

4. Overheating (Oil or Case)

CauseSolution
Incorrect oil viscosityUse the recommended oil grade (e.g., VG46 or VG68).
Continuous operation at peak pressureReview the duty cycle; consider a larger displacement or cooling system.
Cooling system failureCheck the oil cooler and fan.
Case drain blockedEnsure the case drain line is unobstructed and returns to the tank below the oil level.

Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.

Selection Support

Suspect a component failure? Explore our A2FO Pumps or contact our engineers for a diagnostic review.

Frequently Asked Questions

Q: My hydraulic pump is very noisy. Where should I start?
A: Start by checking the suction line for air leaks and ensuring the oil level is correct. Also verify the oil viscosity and the suction pressure.

Q: Why is the flow rate lower than expected?
A: Check if the drive speed is correct. If the pump is worn, internal leakage can reduce the effective flow. Measure the case drain flow to assess wear.

Q: What causes the pump to overheat?
A: Overheating can be caused by operating at peak pressure for too long, using oil with high viscosity, or a failure in the cooling system. Ensure the case drain is not restricted.

Contact

For troubleshooting support, contact HYRIG: info@hyrig.com

Related Pages

Name:
Message:
Verification code:
Submit
Comment