HYRIG can supply the API 6D trunnion ball valve range. The NPS 4 Class 900 trunnion ball valve is a full bore, high-pressure isolation valve. It features a bolted body, spring-loaded seats, and is designed for severe service in mainline pipelines.
| Parameter | Value |
|---|---|
| Design Standard | API 6D, ASME B16.34 |
| Size | NPS 4 (DN 100) |
| Pressure Class | Class 900 |
| Bore Diameter (d) | 100 mm |
| Face-to-Face (RF) | 457 mm |
| Face-to-Face (BW) | 457 mm |
| Height (H) | 245 mm |
| Center to Bottom (H1) | 162 mm |
| Handwheel Diameter (W) | 350 mm |
| Weight (Handwheel) | 141 kg |
| Dimension | Value |
|---|---|
| Face-to-Face (RF) | 457 mm |
| Face-to-Face (BW) | 457 mm |
| Flange Standard | ASME B16.5 |
| Butt Weld End | ASME B16.25 |
| Actuator Mounting | ISO 5211 |
The ball is anchored by upper and lower trunnion bearings, minimizing the operating torque even at 900-class pressure. Spring-loaded seat rings press against the ball from both sides, providing bidirectional sealing. This structure allows for DBB (Double Block and Bleed) operation and prevents seat deformation under high pressure.
Replacing an existing NPS 4 Class 900 valve? Verify: 1. Face-to-face dimension (457 mm for RF/BW). 2. Flange rating (Class 900 ASME B16.5). 3. Actuator torque requirements. 4. DBB cavity vent port availability.
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure if the NPS 4 Class 900 valve fits your system? Share your line pressure, medium, and end connection requirements, and our engineering team will confirm.
Q: What is the pressure rating of Class 900?
Class 900 ASME rating corresponds to approximately 153 bar at ambient temperature, depending on the material group.
Q: What is the weight of the NPS 4 Class 900 valve?
The valve weighs approximately 141 kg with a handwheel operator.
Q: What is the face-to-face dimension?
The face-to-face dimension is 457 mm for both RF and BW ends, conforming to ASME B16.10.
Q: What is the typical lead time?
Standard lead time is typically 4 to 6 weeks depending on material and end connection.
For API 6D trunnion ball valve selection, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.