HYRIG can supply the API 6D trunnion ball valve range. The NPS 6 Class 600 trunnion ball valve is a full bore, bidirectional isolation valve designed for high-pressure pipeline service. It features a bolted body and spring-loaded seats.
| Parameter | Value |
|---|---|
| Design Standard | API 6D, ASME B16.34 |
| Size | NPS 6 (DN 150) |
| Pressure Class | Class 600 |
| Bore Diameter (d) | 150 mm |
| Face-to-Face (RF) | 559 mm |
| Face-to-Face (RTJ) | 562 mm |
| Face-to-Face (BW) | 559 mm |
| Height (H) | 300 mm |
| Center to Bottom (H1) | 209 mm |
| Handwheel Diameter (W) | 400 mm |
| Weight (Handwheel) | 241 kg |
| Dimension | Value |
|---|---|
| Face-to-Face (RF) | 559 mm |
| Face-to-Face (RTJ) | 562 mm |
| Face-to-Face (BW) | 559 mm |
| Flange Standard | ASME B16.5 |
| Butt Weld End | ASME B16.25 |
| Actuator Mounting | ISO 5211 |
The ball is anchored by upper and lower trunnion bearings. Spring-loaded seat rings press against the ball from both sides, providing reliable bidirectional sealing. The double block and bleed (DBB) capability allows operators to verify isolation by venting the body cavity. This design ensures stable operating torque and reduces wear on the sealing components in high-pressure applications.
Replacing an existing NPS 6 Class 600 valve with this model? Verify: 1. Face-to-face dimension (559 mm for RF/BW) to ensure pipeline alignment. 2. Flange facing (Class 600 ASME B16.5). 3. Actuator torque (trunnion design requires specific breakaway torque). 4. DBB requirement (ensure cavity vent is available).
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure if the NPS 6 Class 600 trunnion valve is the correct fit? Share your line pressure, medium, and end connection requirements, and our engineering team will confirm the specifications.
Q: What is the weight of the NPS 6 Class 600 trunnion ball valve?
The valve weighs 241 kg with a handwheel operator. The exact weight may vary slightly depending on the body material (WCB vs CF8M).
Q: What is the face-to-face dimension of this valve?
The face-to-face dimension is 559 mm for RF and BW ends, and 562 mm for RTJ ends, conforming to ASME B16.10.
Q: Can this valve be used for pigging?
Yes. It is a full bore valve, meaning the bore diameter matches the pipeline inner diameter, allowing pigs to pass through.
Q: What is the typical lead time for a 6-inch Class 600 valve?
Standard lead time is typically 4 to 6 weeks. Custom materials or third-party inspection requirements may extend the lead time.
For API 6D trunnion ball valve selection, contact HYRIG: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.