HYRIG can supply the JL series choke valve range and its replacement parts. The JLK103-35 is a manual, adjustable choke valve with a 103 mm (4") nominal bore, engineered to regulate flow and pressure in wellhead and choke manifolds. It features a needle adjusting mode and flange connections for secure integration.
| Model Number | Nominal Diameter | Pressure (MPa) | A (mm) | B (mm) | Connection Type | Adjusting Mode | Actuator |
|---|---|---|---|---|---|---|---|
| JLK103-70 | 103 mm | 70 | 310 | 166 | Flange | Cylinder | Manual |
| JLKY103-70 | 103 mm | 70 | 310 | 166 | Flange | Cylinder | Hydraulic |
| JLK103-35 | 103 mm | 35 | 260 | 260 | Flange | Needle | Manual |
Data source: Technical data table.
Need higher pressure? View the JLK103-70 Adjustable Choke Valve or explore the full JL Choke Valve Series.
The exact footprint for the JLK103-35 configuration is:
Note: The 35 MPa needle-adjustable model has a different footprint (260x260 mm) compared to the 70 MPa cylinder model (310x166 mm). Verify your piping clearance before ordering.
The JLK103-35 utilizes a needle adjusting mode. A tapered needle moves in and out of a seat, providing fine, precise control over the flow area. This is effective for large bore (4-inch) valves where micro-adjustments in lower-pressure environments are needed.
The "K" indicates it is an adjustable valve, allowing dynamic control of the flow area, unlike a fixed "G" choke.
Looking for a replacement for your existing 4-inch choke valve? Here’s what to check:
This valve is specifically suited for:
Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.
Not sure whether you need a cylinder or needle adjusting mode? Tell us your specific flow control requirements, and our engineers will match the correct JLK model for your manifold.
HYRIG provides replacement parts for the JLK103 series, including:
See our JL Choke Valve Parts page for compatible maintenance kits.
Q: What is the nominal diameter of this valve?
A: The nominal diameter is 103 mm (approximately 4 inches).
Q: What adjusting mode does this use?
A: It uses a needle adjusting mode for precise flow control.
Q: What is the working pressure of this model?
A: The maximum working pressure is 35 MPa (5,000 psi).
Q: What standards does this valve meet?
A: It is manufactured according to API 6A and API 16C standards.
For JLK103-35 adjustable choke valve selection and replacement parts, contact HYRIG: info@hyrig.com
Page last updated: 2026-11-08
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.