This page provides complete technical specifications for the Lower IBOP 114706-500 when used with the VARCO TDS-4SA top drive.
| Parameter | Value | Unit |
|---|---|---|
| Working Pressure | 5,000 | psi (34.5 MPa) |
| Shell Test Pressure | 7,500 | psi (51.7 MPa) |
| Seat Test Pressure (high) | 5,000 | psi (34.5 MPa) |
| Seat Test Pressure (low) | 500 | psi (3.4 MPa) |
| Parameter | Value |
|---|---|
| Bore Diameter | 3-1/4" (82.6 mm) |
| Top Connection | 4-1/2" IF female (mates to upper IBOP or top drive) |
| Bottom Connection | 3-1/2" IF male (to saver sub or drill pipe) |
| Overall Length (end to end) | 17.8" (452 mm) typical |
| T-handle length | 12" (305 mm) |
| Component | Material | Specification |
|---|---|---|
| Body & End Pieces | 4130 alloy steel | Heat treated, normalized & tempered |
| Ball | Chrome-plated alloy steel | HRC 55-60, polished |
| Seats | Thermoplastic + NBR energizer | API 16D compliant |
| Stem Seals | NBR O-rings | Durometer 90 |
| T-handle | Carbon steel | Zinc-plated |
| Condition | Min | Max |
|---|---|---|
| Ambient / Fluid | -20°C (-4°F) | 121°C (250°F) |
| Storage | -40°C (-40°F) | 70°C (158°F) |
| Differential Pressure (psi) | Breakaway Torque (N·m) | Running Torque (N·m) |
|---|---|---|
| 0 | 30 | 15 |
| 1,000 | 85 | 45 |
| 2,500 | 145 | 80 |
| 5,000 | 225 | 130 |
Values are approximate and may vary with seal condition and lubrication.
| Connection | Recommended Torque |
|---|---|
| Lower IBOP to upper IBOP / top drive | 13,500 – 15,000 N·m (10,000 – 11,000 ft·lbs) |
| Lower IBOP to saver sub / drill pipe | Per manufacturer specification |
API Spec 7-1 – Thread connections and interchangeability
API 16D – IBOP design, testing, and performance
API Q1 – Quality management system
| Test Type | Pressure | Hold Time | Acceptance Criteria |
|---|---|---|---|
| Low-pressure seat | 500 psi | 5 min | No visible leakage |
| High-pressure seat | 5,000 psi | 5 min | No pressure drop |
| Shell (body) | 7,500 psi | 5 min | No structural leakage |
| Operational | Atmospheric | 3 cycles | Smooth operation |
For 2D/3D CAD drawings, material test reports (MTR), or API 16D test certificates:
Email: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.