Material choice depends on fluid corrosiveness, temperature, pressure, and presence of H₂S or chlorides. All materials comply with API 610 Table H and are fully traceable (EN 10204 3.1).
| Component | Carbon steel (C‑6) | 316L SS (S‑8) | Duplex (D‑1/D‑2) | Low‑temp steel (9% Ni) |
|---|---|---|---|---|
| Outer barrel | Forged low‑alloy | Clad with 316L | Clad with duplex | 9% Ni steel |
| Inner diffuser stack | Carbon steel | 316L SS | Duplex / super duplex | 316L SS |
| Impellers | 304 or carbon steel | 316L SS | Duplex / super duplex | 316L SS |
| Shaft | 4140 (hardened) | 17‑4 PH | Duplex | 17‑4 PH |
| Wear rings | Hardened 4140 | 316L + Stellite | Duplex + Stellite | Stellite on 316L |
| Bolting | B7 (zinc plated) | B8M (316) | Duplex | B8M |
| Fluid | Recommended material | API 610 class | Remarks |
|---|---|---|---|
| Boiler feed water (clean) | Carbon steel (C‑6) | C‑6 | Economical, adequate up to 150°C |
| Deaerated water (moderate corrosion) | 316L SS | S‑8 | Prevents rust carryover |
| Seawater (offshore lift) | Super duplex (U‑8) | U‑8 (PREN >40) | Resists chloride pitting |
| LNG (‑165°C) | 9% nickel steel or 304L SS | S‑8 | Impact tested at cryogenic temperature |
| Sour water / rich amine (H₂S) | 316L SS with NACE MR0175 | S‑8 | Hardness ≤22 HRC |
| High‑temperature hydrocarbons (>200°C) | Carbon steel (C‑6) | C‑6 | With centreline mounting for thermal expansion |
For H₂S‑containing service (sour oil & gas), all pressure‑containing and wetted parts can be supplied with NACE MR0175 certification:
Hardness limits: ≤22 HRC for carbon steel, ≤28 HRC for stainless steel.
No copper alloys (to avoid SSC) unless specified.
Third‑party inspection available (e.g., DNV, BV, Lloyds).
Outer barrel: 9% nickel steel (impact tested at –196°C) or austenitic stainless steel (304L/316L).
Bolting: B8M (316) with cryogenic impact test.
Gaskets: Spiral wound with graphite filler – remains flexible at low temperature.
Mechanical seal: Dual pressurised with barrier fluid that does not freeze (glycol/water mixture).
For any inquiries, please contact: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.