Floating vs Trunnion Ball Valve | Selection Guide & Sizing

2026-11-14 21:28

Floating vs Trunnion Ball Valve

HYRIG supplies both floating and trunnion ball valves. This guide explains the mechanical differences, pressure boundaries, and application criteria to help you choose the correct design for your pipeline.

Key Facts

  • Floating valves: Rely on line pressure for sealing; best for smaller sizes and lower pressures.
  • Trunnion valves: Mechanically anchored ball with spring-loaded seats; required for high pressure and large sizes.
  • Size boundary: Above NPS 8 or Class 300, trunnion is typically more practical.
  • DBB: Only trunnion designs can provide true double block and bleed.

Key Specifications

FeatureFloating Ball ValveTrunnion Ball Valve
Size Range1/2" - 10"1 1/2" - 36"
Pressure Class150 - 1500150 - 2500
Operating TorqueIncreases with pressureRelatively constant
Seat SealingDownstream onlyUpstream and downstream
DBB CapabilityNoYes
PiggingLimited (depends on bore)Full bore available

Dimensions

CriteriaFloatingTrunnion
Face-to-FaceASME B16.10ASME B16.10
Actuator MountingISO 5211ISO 5211
Body Style2-piece bolted2-piece or 3-piece bolted

Structure / Working Principle

Floating: The ball rests between two seat rings. Line pressure pushes the ball into the downstream seat, creating a seal. This design is simple and cost-effective, but the operating torque increases significantly at higher pressures because the ball is pressed harder against the seat.

Trunnion: The ball is held by upper and lower bearings. Line pressure does not push the ball into the seat. Instead, springs push the seat rings against the ball. This design keeps the operating torque low and allows bidirectional sealing, making it suitable for high-pressure and large-diameter pipelines.

Cross-Reference & Replacement

Upgrading from floating to trunnion? Check these factors: 1. Actuator compatibility (trunnion requires less torque). 2. Piping gap (ensure face-to-face dimensions match). 3. DBB requirement (requires cavity bleed port).

Applications

  • Floating: Utility lines, small-bore manifolds, low-pressure chemical injection, general plant service.
  • Trunnion: Mainline gas transmission, high-pressure oil pipelines, pig launcher isolation, DBB isolation points.

Disclaimer: This equipment is designed for high-pressure industrial applications. Ensure strict compliance with local safety standards and verify pressure ratings prior to installation.

Selection Support

Still unsure which design to choose? Provide your line size, pressure class, and operating medium, and our engineers will recommend the correct valve type.

Frequently Asked Questions

Q: Can I use a floating ball valve for a 12-inch pipeline?

No. A 12-inch floating valve would require extremely high operating torque and is not practical. Trunnion valves are standard for NPS 10 and above.

Q: Do I need a trunnion valve for Class 600?

Not always. For smaller sizes (NPS 1 to 4), a floating valve in Class 600 is common. For NPS 6 and above, trunnion is recommended.

Q: What is the cost difference?

Floating valves are generally more cost-effective for smaller sizes. Trunnion valves have higher upfront costs due to the bearing and spring mechanism but offer lower operating torque and longer service life in severe conditions.

Contact

For help selecting between floating and trunnion valves, contact HYRIG: info@hyrig.com

Related Pages

Name:
Message:
Verification code:
Submit
Comment