Vertical Barrel Pump – Quality Assurance & Testing per API 610

QR code
share
WeChat
Sina Weibo
QQ
QQ space
Douban
Baidu Post Bar
copy Link
Facebook
X
LinkedIn
Pinterest
Line
Tumblr
API 610 VS6 vertical barrel pump with comprehensive quality assurance: hydrostatic test to 1.5× design pressure, performance test per API 610 Grade 2, NPSH test, NDE (UT/MT/PT), and EN 10204 3.1 material certification. Third‑party inspection available.

Conatct For Details
DetailReview(0)Additional

Mandatory API 610 Tests

Every vertical barrel pump undergoes the following tests as a minimum.

1. Hydrostatic Test

  • Casing (outer barrel): 1.5× maximum allowable working pressure (MAWP)

  • Hold time: 30 minutes minimum

  • Acceptance: No visible leakage or pressure drop

2. Performance Test

  • Grade: API 610 Grade 2 (Grade 1 optional)

  • Fluid: Water at rated speed (or test speed)

  • Points: Shut‑off, 25%, 50%, 75%, 90%, 100%, 110% of BEP flow

  • Measured: Head, flow, power, efficiency, NPSHr

  • Tolerance: Per API 610 Table 24

3. NPSH Test (when specified)

  • Method: Constant flow, reduce suction pressure until 3% head drop

  • Report: NPSHr curve at rated speed

4. Mechanical Run Test

  • Duration: 4 hours minimum at rated speed (or maximum continuous speed)

  • Monitor: Bearing temperature (rise ≤40°C), vibration velocity (≤3 mm/s rms)

  • Record: Discharge pressure, power, ambient conditions

Non‑Destructive Examination (NDE)

ComponentNDE methodAcceptance criteria
Outer barrel (forging)Ultrasonic (UT)No flaws >1.5 mm equivalent
ShaftUltrasonic (UT) + Magnetic Particle (MT)API 610 / ASME Section VIII
Impeller (cast)Dye Penetrant (PT) or Radiography (RT)No surface cracks
Weld joints (barrel to flange)Radiography (RT) or UTFull penetration, no defects

Material Certification

  • Standard: EN 10204 Type 3.1 – full chemical and mechanical test reports, traceable to heat number.

  • Optional: EN 10204 Type 3.2 (third‑party inspection by Lloyds, DNV, BV, etc.)

Positive Material Identification (PMI) – Available for alloy verification (e.g., 316L, duplex, 9% Ni).

Witnessed & Third‑Party Inspection

We welcome customer or third‑party witnesses for all tests. Typical inspection bodies:

  • Lloyds Register

  • DNV

  • Bureau Veritas

  • SGS

  • TÜV

Documentation Package

Each pump is supplied with:

  • Certified performance curve (including NPSH curve when tested)

  • Hydrostatic test certificate

  • Material certificates (EN 10204 3.1)

  • Dimensional outline drawing

  • Cross‑sectional drawing

  • Instruction & maintenance manual

  • Mechanical seal data sheet (API 682)

For any inquiries, please contact: info@hyrig.com


Comment

comment
Name
Praise degree
Message:
Upload pictures:
    total 0 Sheet,Only 5 images can be uploaded, each less than 5m.
    Verification code
    Submit