| Cost factor | Conventional pump + foot valve | Self‑priming pump | Annual saving (typical) |
|---|---|---|---|
| Foot valve maintenance | Replace every 6‑12 months | Not required | $500‑1,500 |
| Manual priming labour | Each start (hazardous fluids) | Eliminated | $1,000‑5,000 |
| Suction line cleaning | Debris stuck in foot valve | No valve to clog | $500‑1,000 |
| Downtime due to loss of prime | Frequent (air leaks, valve failure) | Rare (automatic re‑prime) | $5,000‑20,000 (process loss) |
Our self‑priming pump uses the same high‑efficiency hydraulics as standard API 610 pumps – no penalty for self‑priming ability. Double volute casing (DN80+) reduces radial thrust, lowering bearing wear and parasitic power loss.
Efficiency at BEP: Up to 85% (larger sizes)
IE3/IE4 motor as standard
VFD ready for variable flow – reduces energy consumption at partial load
No foot valve – eliminates one piping component.
Suction pipe can be shorter and simpler (no need to accommodate valve removal).
Pump can be located above grade – no pit excavation in many cases.
| Item | Conventional pump | Self‑priming pump |
|---|---|---|
| Initial purchase | Lower (no self‑priming casing) | +15‑20% |
| Foot valve replacements (every year) | 15 units | 0 |
| Labour for priming (2 hours/week) | 1,560 hours | 0 |
| Seal replacements (due to dry runs) | 3‑4 times | 1‑2 times |
| Unplanned downtime | Moderate | Very low |
| Total 15‑year cost | Higher | Lower by 25‑40% |
The higher initial cost of an API 610 self‑priming pump is typically recovered in 6‑18 months through savings in maintenance, labour, and reduced downtime.
For any inquiries, please contact: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.