Self‑Priming Pump – Operation, Maintenance & Troubleshooting

QR code
share
WeChat
Sina Weibo
QQ
QQ space
Douban
Baidu Post Bar
copy Link
Facebook
X
LinkedIn
Pinterest
Line
Tumblr
API 610 self‑priming pump – full O&M guidance: initial fill & priming check, bearing lubrication schedule, mechanical seal replacement procedure, troubleshooting common problems (loss of prime, low flow, excessive vibration).

Conatct For Details
DetailReview(0)Additional

Commissioning – First Start

  1. Fill the casing with liquid through the priming port. Ensure the stored liquid volume is adequate (mark on casing).

  2. Close discharge valve partially (about 30% open) to reduce starting load.

  3. Start motor – pump should prime within 2‑3 minutes (depending on suction lift).

  4. Open discharge valve slowly to operating point.

  5. Check for leaks at mechanical seal, flanges, and drain plugs.

Daily / Weekly Checks

  • Suction line – no air leaks (visible liquid drips or pressure instability).

  • Stored liquid – ensure casing has not lost liquid (through evaporation or leak).

  • Vibration and bearing temperature – compare to baseline.

  • Mechanical seal – no visible dripping from seal chamber drain.

Lubrication

ComponentLubricantQuantityChange interval
Bearing housing (oil bath)ISO VG 68 synthetic or mineralTo oil level indicator8,000 hours or 1 year
Grease‑lubricated bearingsNLGI 2 lithium complexFill cavity 30‑50%2,000 hours (high speed)

Mechanical Seal Replacement (Back Pull‑Out)

  1. Isolate pump, drain casing.

  2. Remove coupling guard, disconnect spacer coupling.

  3. Unbolt bearing housing from casing.

  4. Pull rotating assembly (shaft, bearings, seal chamber) out of casing.

  5. Remove old seal cartridge, install new API 682 cartridge.

  6. Re‑assemble – no alignment needed because cartridge is pre‑set.

Troubleshooting

ProblemLikely causeRemedy
Pump does not primeCasing lost stored liquid, suction air leak, recirculation port blockedRefill casing, tighten suction joints, clean port
Priming too slowSuction pipe too long/diameter too large, low impeller speedShorten pipe, install larger impeller, check voltage
Pump loses prime after runningAir leak in suction line, vortexing at strainerRepair leak, lower strainer or increase submergence
Low flow / headImpeller or wear ring worn, voltage low, suction strainer cloggedReplace wear parts, check supply voltage, clean strainer
Excessive vibrationCavitation (NPSH insufficient), misalignment, impeller imbalanceIncrease NPSHa, re‑align, balance impeller

Storage (more than 3 months)

  • Drain completely, flush with clean water/inhibitor.

  • Apply rust preventive to machined surfaces.

  • Rotate shaft manually monthly to prevent bearing brinelling.

  • Store in dry, covered area.

For any inquiries, please contact: info@hyrig.com


Comment

comment
Name
Praise degree
Message:
Upload pictures:
    total 0 Sheet,Only 5 images can be uploaded, each less than 5m.
    Verification code
    Submit